PIVOT BOLT COVER
J064892017-08-22
GENERAL
Kit Number
61400346
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
WARNINGRider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
INSTALLATION
Right Side Pivot Bolt Cover Installation
- See Figure 1. Start a set screw (1) from the kit into the right side pivot bolt cover (2) about two or three turns.
- Note the position of the bottom-most flat on the rear fork pivot bolt (3). Line up the pivot bolt cover over the bolt head so the set screw is centered on the hex flat. Tighten the set screw securely to the head of the rear fork pivot bolt.
| 1 | Set screw |
| 2 | Pivot bolt cover (right sided) |
| 3 | Right side rear fork pivot bolt |
Figure 1. Right Side Pivot Bolt Cover Installation
Left-Side Pivot Bolt Cover Installation
- See Figure 2. Start a set screw (1) from the kit into the pivot bolt cover (2) about two or three turns.
- Note the position of the bottom-most flat on the rear fork pivot nut (3). Line up the pivot bolt cover over the bolt head so the set screw is centered on the hex flat. Verify that the washer (4) is centered and the cover fits. If not, refer to the service manual on how to loosen and tighten the pivot bolt. Tighten the set screw securely to the head of the rear fork pivot nut.
| 1 | Set screw |
| 2 | Left side pivot nut cover |
| 3 | Left side rear fork pivot nut |
| 4 | Washer |
Figure 2. Left side Pivot Nut Cover Installation
CARE AND CLEANING GUIDELINES FOR BRASS PARTS
Cleaning Instructions
- Verify part is dry and free of dirt or debris.
- Place a small amount of Harley-Davidson® Chrome Clean & Shine on a microfiber cloth or detailing swab.
- Using light pressure, rub the brass parts with the microfiber cloth. For hard to reach places or grooves, use the detailing swab.
Obtaining a Bright Finish
Brass parts will naturally age and darken with time. If a bright brass finish is preferred, place some Harley-Davidson Bare Metal Polish on a microfiber cloth and lightly rub on the brass parts until they reach the desired brightness.
Slowing the Natural Aging Process
To slow the aging process of the brass parts, place a small amount of Harley-Davidson Glaze Poly Sealant on a microfiber cloth or detailing swab, and lightly rub on the parts until the sealant has soaked in.
Precautions
- Use of non-recommended cleaning, polishing and protective products will result in the removal of the aged finish from the brass parts.
- Prolonged contact with certain items (hands, gloves, boots, dust, etc.) and exposure to the elements will also alter all surface finishes and is NOT considered a defect.
- Avoid cleaning parts with abrasive and aggressive chemicals and abrasive cleaning pads.
- Avoid ammoniated products and bleach.
- Prolonged exposure to water will alter the brass finish. Wipe down parts after contact with water.
- Excess rubbing may lighten the surface appearance of the part.
SERVICE PARTS
Figure 3. Service Parts:Pivot Bolt Cover Kit
Table 1. Service Parts: Pivot Bolt Cover Kit
Item | Description (Quantity) | Part Number |
|---|---|---|
1 | Set screw, hex socket, cup point, locking (2) | 3194 |
2 | Cover, pivot bolt (2) | Not sold separately |