BLACK MILWAUKEE-EIGHT ENGINE TOP KIT

J067912019-08-22

Table 1. General Information

Kits	Suggested Tools	Skill Level⁽¹⁾	Time
12600254	Safety Glasses, Torque Wrench		10 hours

(1) Special tools or techniques required for installation

KIT CONTENTS

Figure 1. Kit Contents: Engine Top Components

Table 2. Engine Top Components

Item	Qty	Description	Part No.	Replace	Notes
1	20	Screw	10200954	10200308	Follow torque specification and torque sequence per service manual Installation requires removal of fuel tank
2	2	Screw	10200955	10200408A	Follow torque specification and torque sequence per service manual Installation requires removal of engine to install
3	2	Screw	10200956	10200475	Touring models: Not used Follow torque specification and torque sequence per service manual
4	2	Screw	10200991	4188 (4775 Touring)	Follow torque specification and torque sequence per service manual
5	2	Washer	10300217	6139 (6019 Touring)	Follow torque specification and torque sequence per service manual

NOTE

Verify all contents are present in the kit before installing or removing items from vehicle.

GENERAL

Models

For model fitment information, please see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).

Ensure you are using the most current version of the instruction sheet which is available at: www.harley-davidson.com/isheets

Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.

Installation Requirements

WARNING

Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)

WARNING

When servicing the fuel system, do not smoke or allow open flame or sparks in the vicinity. Gasoline is extremely flammable and highly explosive, which could result in death or serious injury. (00330a)

REMOVE

1.	Disconnect main fuse. See service manual.
2.	Remove fuel tank. See service manual.
3.	Remove seat. See service manual.

INSTALLL

Remove and Replace

NOTE

See the service manual of the year and model vehicle that the service is being performed on for the following steps.
Follow torque specification and installation sequence per service manual for screws (1 thru 4).
Remove and replace each screw/washer one at a time to maintain initial clamp load.
Texture black touch-up pen (98605BF) or bottle (98600BF) can be used for coverage of imperfection on engine covers.

1.	Fully remove one Original Equipment (OE) screw.
2.	Install new black screw.
3.	Tighten screw.
4.	Repeat steps 1 through 3 for remaining screws. Replace screws individually following torque sequence per service manual.
5.	Install fuel tank. See service manual.
6.	Install seat. After installing seat, pull up on the seat to verify that it is secure. See service manual.
7.	Connect main fuse. See service manual.