OVERWATCH HANDLEBAR BAG, SMALL

J068042019-08-19

GENERAL INFORMATION

Table 1. General Information

Kits	Suggested Tools	Skill Level⁽¹⁾	Time
93300121	Safety Glasses		15 minutes

(1) Only simple tools and techniques required

KIT CONTENTS

Figure 1. Kit Contents: Overwatch Handlbar Bag Components

Table 2. Kit Contents: Overwatch Handlbar Bag Components

Item	Qty	Description	Part No.
1	1	Bag, handlebar, small	Not sold separately
2	6	Hook-and-Loop	93500026
3	1	Anti-abrasion tape	Not sold separately

NOTE

Verify all contents are present in the kit before installing or removing items from vehicle.

GENERAL

Models

For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).

Verify that the most current version of the instruction sheet is used. It is available at: www.harley-davidson.com/isheets

Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.

Installation Requirements

WARNING

Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)

PREPARE

Cut anti-abrasion tape (3) to fit area being applied to.

a. Nacelle

b. Headlight bracket

INSTALL

WARNING

Do not exceed Handlebar Bag weight capacity. Too much weight in Handlebar Bag can cause loss of control, which could result in death or serious injury. (06705a)

NOTE

Weight of contents must not exceed weight limit of 2.5 lbs (1.1 kg).

1.	Figure 2 Attach a minimum of four hook-and-loops to back of bag.
2.	Figure 3 Secure hook-and-loops on bag to handlebar (2) and risers (3). NOTE When installing hook-and-loops to risers and handlebar be careful not to pull on, squeeze or pinch any wiring or cables. Verify full range of movement by turning handlebars lock-to-lock. Verify that bag does not cover up lighting, turn signals, reflectors, instruments cluster or warning lights. Depending on vehicle model and configuration, bag can be mounted in front of or behind handlebars.
3.	Tighten hook-and-loops as much as possible.
4.	Trim excess hook-and-loop straps once installed.
5.	Periodically recheck mounting straps and cargo.

1	Vertical install through strap
2	Horizontal install through clip

Figure 2. Hook-and-Loop Attachment Options

1	Bag
2	Handlebar
3	Risers

Figure 3. Bag and Hook-and-Loop Attachment

CARE AND MAINTENANCE INSTRUCTIONS

1.	Use a lint free cloth to wipe off any dust or dirt.
2.	Thoroughly clean outer surface with warm water and a mild detergent.
3.	Do not use artificial means to dry material quickly.
4.	Contains one or more of the following materials: a. Polyester b. Polypropylene c. Polyethylene