0/0
Headlamp Trim - Chrome / Black
J070662017-01-16
GENERAL
Kit Number
61400411, 61400412
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
INSTALLATION
NOTE
  • Ambient temperature should be between 21 °C (70 °F) and 38 °C (100 °F) for proper adhesion. Do not apply below 10 °C (50 °F).
  • Parts cannot be repositioned after initial adhesive installation.
  • Allow AT LEAST 24 hours after application before exposing the area to vigorous washing, strong water spray or extreme weather.
  • The adhesive bond will increase to maximum strength after about 72 hours at normal room temperature.
  • Do not clean with denatured alcohol, mineral spirits or other solvents. Damage to components may occur.
  1. Using a 50:50 isopropyl alcohol/water solution, thoroughly clean trim mounting surfaces. Allow to dry completely.
  2. Install headlamp trim.
    1. With the adhesive backing still in place, test fit the headlamp trim to mounting location.
    2. See Figure 1. Remove the adhesive backing. Install the headlamp trim to the fairing.
    3. Press surface of trim firmly to make sure that there is good adhesion.
Figure 1. Adhesive Strip Areas