1. | Figure 1 Remove four screws (2) and rubber washer (3). Retain hardware. | |
2. | Remove windshield (1). | |
3. | Figure 2 Remove vent (1). | |
4. | Figure 3 Remove the E-clip (4). | |
5. | Remove pin (1). | |
6. | Rotate bracket (3). | |
7. | Remove Original Equipment (OE) grommet (2). a. Retain OE grommet and windshield for later installation. | |
8. | Repeat steps 4-7 for opposite side. |
1. | Figure 3 Install new grommet (2) from kit. | |
2. | Rotate bracket (3). | |
3. | Install pin (1). | |
4. | Install E-clip (4). | |
5. | Repeat steps 1-4 for opposite side. | |
6. | Figure 2 Install vent (1). | |
7. | Figure 1 Install new windshield (1) from kit. | |
8. | Spray rubber washers (3) with a 50/50 isopropyl alcohol/water solution. This will help aligning the washer in the windshield. | |
9. | Install four rubber washers (3) and screws (2). Tighten. Torque: 3.5–4.5 N·m (31–40 in-lbs) Windshield screw |
1 | Windshield |
2 | Screw (4) |
3 | Rubber washer (4) |
1 | Vent |
1 | Pin |
2 | Grommet (2) |
3 | Bracket (2) |
4 | E-Clip (2) |
1 | Grommet (2) |
2 | Windshield |
Item | Description (Qty) | Part Number | Kit Number |
---|---|---|---|
1 | Grommet (2) | 12100192 (Gray) | 57400456, 57400499 |
12100169 (Black) | 57400454 | ||
2 | Windshield, tall, clear | Not sold separately | 57400454 |
Windshield, short, dark | Not sold separately | 57400456 | |
Windshield, short, clear | Not sold separately | 57400499 |