MILWAUKEE-EIGHT FAN ASSISTED OIL COOLER KIT
941002392024-06-19
GENERAL INFORMATION
Table 1. General Information
Kits
Suggested Tools
Skill Level(1)
26800195
Safety Glasses, Torque Wrench, Digital Technician II (DT II)
3 Dark wrench
(1) DTII and dealer installation required
KIT CONTENTS
Figure 1. Kit Contents: Milwaukee-eight Fan Assisted Oil Cooler Kit
Table 2. Kit Contents: Milwaukee-eight Fan Assisted Oil Cooler Kit
Verify that all contents are present in the kit before installing or removing items from vehicle.
Item
Qty
Description
Part No.
Notes
1
Oil cooler fan
Not sold separately
GENERAL
Instruction sheet is also available electronically. To verify you are using the most current version available, do one of the following:
  • Scan QR code in upper left corner of the instruction sheet
NOTE
This instruction sheet may have a Supplemental Video to assist installer in clarifying a certain part of the assembly. A linked video would be located at the end of this instruction sheet.
Models
For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNING
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for the year and model motorcycle is required for this installation and is available from:
These items are available at your local Harley-Davidson dealership.
PREPARE
1. Remove main fuse. See service manual.
REMOVE
1. Remove oil cooler cover. See service manual.
2. See Figure 2. Remove screws (1).
1Screw (2)
2Oil cooler
Figure 2. Oil Cooler Screws
INSTALL
1. See Figure 3. Install oil cooler fan (2) to oil cooler (1).
a. Rotate and lift oil cooler assembly.
2. Install fan assisted oil cooler assembly to vehicle.
a. See Figure 2. Install and tighten screws (1).
Torque: 11–13.5 N·m (97–119 in-lbs)
3. See Figure 3. Connect oil cooler fan connector (3) to vehicle harness (1). See Figure 4.
4. Install oil cooler cover. See service manual.
1Oil cooler
2Oil cooler fan
3Connector
Figure 3.
1Vehicle harness
Figure 4. Vehicle Harness
COMPLETE
1. Install main fuse. See service manual.
2. Calibrate ECM using special tool. See Harley-Davidson dealer.

Special Tool: DIGITAL TECHNICIAN II (HD-48650)