ADVENTURE JIFFY STAND
941002782022-11-21
GENERAL INFORMATION
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) |
|---|---|---|
50000248, 50000264, 50000248A, 50000264A | Safety Glasses, Torque Wrench |  |
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Jiffy Stand (typical)
Table 2. Kit Contents: Jiffy Stand (typical)
 | Verify that all contents are present in the kit before installing or removing items from vehicle. | ||||
|---|---|---|---|---|---|
Item | Qty | Description | Part No. | Notes | |
 | 1 | 1 | Jiffy stand | Not sold separately | |
| 2 | 1 | Bumper | 50245-07 | |
GENERAL
Models
For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.
Verify that the most current version of the instruction sheet is used. It is available at: h-d.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
LOCTITE SILVER GRADE ANTI-SEIZE (11100001) is required for this installation.
WARNINGRider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for the year and model motorcycle is required for this installation and is available from:
- A Harley-Davidson dealer.
- H-D Service Information Portal, a subscription-based access available for most 2001 and newer models. For more information see Frequently ask questions about subscriptions.
PREPARE
| 1. | Set vehicle upright. See service manual. | |
| 2. | Disconnect jiffy stand sensor, if equipped. See service manual. |
REMOVE
| 1. | Remove jiffy stand. See service manual. |
INSTALL
| 1. | Figure 2 Install bushing (8) on bracket (1). | |
| 2. | Install jiffy stand (5). | |
| 3. | Install bushing (2). | |
| 4. | Apply anti-seize lubricant to pivot pin (7).LOCTITE SILVER GRADE ANTI-SEIZE (11100001) | |
| 5. | Install pivot pin (7). | |
| 6. | Install nut (3). Tighten. Torque: 10.3–11.4 N·m (91–101 in-lbs) | |
| 7. | Apply anti-seize lubricant to spring hook groove on jiffy stand bracket.LOCTITE SILVER GRADE ANTI-SEIZE (11100001) NOTE Spring hooks must face rear of motorcycle when jiffy stand is in down position. | |
| 8. | Install spring (6). |
| 1 | Jiffy stand bracket |
| 2 | Bushing |
| 3 | Nut |
| 4 | Bumper |
| 5 | Jiffy stand |
| 6 | Spring |
| 7 | Pivot pin |
| 8 | Bushing |
Figure 2. Jiffy Stand Assembly (Typical)
COMPLETE
| 1. | Connect jiffy stand sensor, if equipped. See service manual. |