REVOLUTION MAX - HEAVY BREATHER
941003302022-03-07
GENERAL INFORMATION
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) |
|---|---|---|
29400440, 29400442 | Safety Glasses, Torque Wrench |  |
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Revolution Max -Heavy Breather
Table 2. Kit Contents: Revolution Max -Heavy Breather
 | Verify that all contents are present in the kit before installing or removing items from vehicle. | ||||
|---|---|---|---|---|---|
Item | Qty | Description | Part No. | Notes | |
 | 1 | 2 | Screw, flange, M12 | 10201013 | |
| 2 | 1 | Screw, flange, M6 | 10200899 | |
| 3 | 1 | Heavy breather assembly | Not sold separately | |
| 4 | 1 | Air filter, chrome | 29400275 | |
Air filter, black | 29400276 | ||||
GENERAL
Models
For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.
Verify that the most current version of the instruction sheet is used. It is available at: h-d.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNINGRider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for the year and model motorcycle is required for this installation and is available from:
- A Harley-Davidson dealer.
- H-D Service Information Portal, a subscription-based access available for most 2001 and newer models. For more information see Frequently ask questions about subscriptions.
PREPARE
NOTE
Air filter is located inside air box assembly.
| 1. | Remove and discard Original Equipment (OE) air filter. See service manual. a. Reassemble air box assembly after discarding OE air filter. |
REMOVE
| 1. | Figure 2 Remove OE right side valley cover. a. Pull cover (1) off and discard. | |
| 2. | Figure 3 Remove right side valley cover bracket. a. Remove small screw (2) and discard. b. Remove large screws (1) and discard. c. Remove bracket (3). |
| 1 | Cover |
Figure 2. Right Side Valley Cover
| 1 | OE Large screw (2) |
| 2 | OE Small screw |
| 3 | Bracket |
Figure 3. Bracket
INSTALL
| 1. | Figure 5 Install heavy breather assembly. | |
| 2. | Install small screw (2). Tighten. Torque: 5.8–7.9 N·m (51–70 in-lbs) Small screw | |
| 3. | Install large screws (1). Tighten. Torque: 108–119 N·m (80–88 ft-lbs) Large screw | |
| 4. | Install air filter (4). | |
| 5. | Tighten clamp (5). |
| 1 | Clamp |
| 2 | Seal |
Figure 4. Seal
| 1 | Large screw (2) |
| 2 | Small screw |
| 3 | Heavy breather assembly |
| 4 | Air filter |
| 5 | Clamp |
Figure 5. Heavy Breather