Kits | Suggested Tools | Skill Level(1) |
---|---|---|
76001294 | Safety Glasses, Torque Wrench |
Verify that all contents are present in the kit before installing or removing items from vehicle. | |||||
---|---|---|---|---|---|
Item | Qty | Description | Part No. | Notes | |
1 | 1 | Amplifier, primary audio | Not sold separately |
1. | Remove left saddlebag. See service manual. | |
2. | Remove left side cover. See service manual. | |
3. | Remove main fuse. See service manual. | |
4. | Remove outer fairing. See service manual. |
1. | Figure 2 Remove Original Equipment (OE) amplifier. a. Remove screws (1). b. Remove amplifier (3). c. Disconnect connector (2). |
1. | Figure 2 Install amplifier. | |
2. | Connect connector (2). | |
3. | Install amplifier (3) on mounts. | |
4. | Install screws (1). Tighten. Torque: 5.5–6.8 N·m (49–60 in-lbs) |
1 | Screw (4) |
2 | Connector |
3 | Amplifier |
1. | Install outer fairing. See service manual. | |
2. | Install main fuse. See service manual. | |
3. | Install left side cover. See service manual. | |
4. | Install left saddlebag. See service manual. |
1. | From the www.harley-davidson.com website. a. Select: Software Updates. This links to Infotainment Support Resources. b. Select: Infotainment Control Unit (IFCU) SkylineTM OS Located in Table of Content. c. Follow the instructions to transfer the update to the (IFCU) and Amplifiers as equipped. | |
2. | Perform system configuration ONLY after all audio accessory kits have been installed. | |
3. | Power up vehicle in accessory mode. | |
4. | On the Infotainment Control Unit (IFCU): a. Select: Settings icon. b. Select: Sounds Settings. c. Follow on screen prompts for applicable audio system changes. | |
5. | When complete, turn power off for 60 seconds. | |
6. | Turn the ignition ON, but do not start the vehicle. | |
7. | Make sure that all speakers are working properly. Check that front and rear fader function is operating correctly. If not, check speaker wiring. Installation Requirements |