0/0
SCREAMIN EAGLE OHLINS FRONT SUSPENSION
941004562024-07-22
GENERAL INFORMATION
Table 1. General Information
Kits
Suggested Tools
Skill Level(1)
45400355, 45400356
Safety Glasses, Torque Wrench
(1) Special tools or techniques required for installation
KIT CONTENTS
Figure 1. Kit Contents: Screamin Eagle Ohlins Front Suspension
Table 2. Kit Contents: Screamin Eagle Ohlins Front Suspension
Verify that all contents are present in the kit before installing or removing items from vehicle.
Item
Qty
Description
Part No.
Notes
1
1
Inverted fork
Not sold separately
Kit 45400355
2
1
Traditional fork
Not sold separately
Kit 45400356
3
2
Fork spring
Not sold separately
4
2
O-ring
Not sold separately
5
2
Guide ring
Not sold separately
Kit 45400356
6
1
Fork oil
62600133
Not shown
7
1
Ohlins Instructions FKS 525
Not sold separately
Kit 45400355
Ohlins Instructions FKS 230
Not sold separately
Kit 45400356
8
1
Fork bottom O-ring
11900219
Kit 45400355
Table 3. Screamin Eagle/Ohlins Front Suspension Preload Table
Rider Weight
All Front Forks (Except FXBB)
FXBB Front Forks
LBS
KG
Turns from Minimum1
Turns from Minimum1
<150
<68
6
0
160
73
6
0
170
77
7
0
180
82
7
0
190
86
8
0
200
91
9
1
210
95
9
1
220
100
10
2
230
104
11
3
240
109
11
3
250
113
12
4
260
118
13
5
270
122
13
5
280
127
14
6
290
132
14
6
300 to GVWR
136 to GVWR
15
7
NOTE
DO NOT exceed Gross Vehicle Weight Rating (GVWR) for any loading condition.
(1) Make fork preload changes to both forks as specified.
GENERAL
Instruction sheet is also available electronically. To verify you are using the most current version available, do one of the following:
  • Go to h-d.com/isheets
  • Scan QR code in upper left corner of the instruction sheet
This instruction sheet may have a Supplemental Video to assist installer in clarifying a certain part of the assembly. A linked video would be located at the end of this instruction sheet.
Models
For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNING
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for the year and model motorcycle is required for this installation and is available from:
PREPARE
1. Remove front wheel. See service manual.
2. Remove front fender. See service manual.
3. Remove windshield, if equipped. See service manual.
4. Remove front brake caliper(s). See service manual.
5. FLFBS, FLHC, FLHCS: Remove rear headlamp nacelle panels. See service manual.
REMOVE
1. Remove front fork tube assemblies. See service manual.
2. Disassemble front fork tube assemblies. See service manual.
INSTALL
1. See Öhlins® instructions FKS525 or FKS230 supplied with this kit.
a. Verification for the most current version of installation instructions, refer to the Öhlins® website or contact their customer service.
COMPLETE
1. FLFBS, FLHC, FLHCS: Install rear headlamp nacelle panels. See service manual.
2. Install front brake caliper(s). See service manual.
3. Install windshield, if equipped. See service manual.
4. Install front fender. See service manual.
5. Install front wheel. See service manual.