Kits | Suggested Tools | Skill Level(1) |
---|---|---|
57400668 | Safety Glasses, Torque Wrench |
Verify that all contents are present in the kit before installing or removing items from vehicle. | |||||
---|---|---|---|---|---|
Item | Qty | Description | Part No. | Notes | |
1 | 1 | Tall windshield mounting block, right | Not sold separately | ||
2 | 1 | Tall windshield mounting block, left | Not sold separately | ||
Items mentioned in text, but not included in kit | |||||
A | 4 | Original Equipment (OE) screw |
1. | Remove windshield if present. |
1. | See Figure 2. Remove right and left mounting block screws (2). Retain screws. | |
2. | Remove cover from duct assembly. See service manual. | |
3. | Remove screws retaining right and left mounting blocks from underside of cover. a. Discard mounting blocks and retain screws for later use. |
1 | Mounting block (2) |
2 | Screw (4) |
1. | See Figure 3. Install new mounting blocks to cover. a. Align and engage mounting block alignment pin with hole in cover. b. Secure mounting block to cover with OE screw. Tighten. Torque: 2.5–3.6 N·m (22–32 in-lbs) c. Repeat on other side. | |
2. | Install cover to duct assembly. See service manual. | |
3. | See Figure 1. Secure right and left mounting blocks (1,2) with OE screws (A). Tighten. Torque: 2.8–3.4 N·m (25–30 in-lbs) |
1 | Alignment pin, right mounting block |
2 | Alignment pin, left mounting block |
3 | "R", right mounting block |
4 | "L", left mounting block |