AXLE COVERS
941004942024-07-02
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) |
|---|---|---|
43000314, 43000315, 43000316, 43000317, 43000318 | Safety glasses, Flathead screwdriver, Isopropyl alcohol |   |
(1) Only simple tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Axle Covers
Table 2. Kit Contents: Axle Covers (Front shown)
 | Item | Qty | Description | Part No. | Notes |
|---|---|---|---|---|---|
 | 1 | 1 | Axle cover, large insert (right side) | Not sold separately | |
| 2 | 1 | Axle cover, small insert (left side) | Not sold separately | |
| 3 | 1 | O-ring, (right side), not shown | 11900206 | ALL kits |
| 1 | O-ring, (left side), not shown | 11900207 | ALL kits |
NOTE
Verify all contents are present in the kit before installing or removing items from vehicle.
GENERAL
Models
For model fitment information, please see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Ensure you are using the most current version of the instruction sheet which is available at: www.harley-davidson.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNINGRider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
REMOVE
| 1. | Place edge of screwdriver into notch located at bottom of axle cover. | |
| 2. | Gently pry outward to remove. |
INSTALL
| 1. | Clean axle openings with 50/50 isopropyl alcohol and water mixture. | |||||||||
| 2. | Figure 1 Install right axle cover (1). a. Figure 2 Align flats of spring clip (2) with axle's internal hex flats (3). b. Push axle cover into axle until O-ring (4) makes contact. c. Rotate axle cover logo as needed (if applicable). d. Press firmly on axle cover until fully installed. | 
Figure 2. Align Flats | ||||||||
| 3. | Figure 1 Install left axle cover (2). a. Push axle cover into axle until O-ring makes contact. b. Rotate axle cover logo as needed (if applicable). c. Press firmly on axle cover until fully installed. |