RESERVOIR BRACKET KIT
941006382024-04-24
GENERAL INFORMATION
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) |
|---|---|---|
54000383A | Safety Glasses, Torque Wrench, Loctite 243 (blue) |  |
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Reservoir Bracket Kit
Table 2. Kit Contents: Reservoir Bracket Kit
 | Verify that all contents are present in the kit before installing or removing items from vehicle. | ||||
|---|---|---|---|---|---|
Item | Qty | Description | Part No. | Notes | |
 | 1 | 1 | Reservoir bracket, black, right | Not sold separately | |
| 2 | 1 | Reservoir bracket, black, left | Not sold separately | |
| 3 | 1 | Spacer kit | Not sold separately | |
GENERAL
Models
For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.
Verify that the most current version of the instruction sheet is used. It is available at: h-d.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
Separate purchase of threadlocker is required. LOCTITE 243 MEDIUM STRENGTH THREADLOCKER AND SEALANT (BLUE) (99642-97)
WARNINGRider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for the year and model motorcycle is required for this installation and is available from:
- A Harley-Davidson dealer.
- H-D Service Information Portal, a subscription-based access available for most 2001 and newer models. For more information see Frequently ask questions about subscriptions.
PREPARE
| 1. | Remove saddlebags. See service manual. |
REMOVE
| 1. | Figure 2 Remove screws (1). | |
| 2. | Remove Original Equipment (OE) remote reservoir bracket (2). a. Do not remove or loosen any of the remote reservoir hoses or bolts. b. Remove reservoir mounting screws (3). Save screws for reuse. Discard original bracket. | |
| 3. | Repeat steps for opposite side of vehicle. |
| 1 | Screw, reservoir bracket (2) |
| 2 | Remote reservoir bracket |
| 3 | Screw, reservoir mount (2) |
Figure 2. Remote Reservoir Bracket
INSTALL
| 1. | Figure 2 Install new reservoir bracket. a. Apply threadlocker to threads of screws (3).LOCTITE 243 MEDIUM STRENGTH THREADLOCKER AND SEALANT (BLUE) (99642-97) b. Install reservoir to new mounting bracket. c. Tighten. Torque: 10.2–12.9 N·m (90–114 in-lbs) | |
| 2. | If installing reservoir brackets in original position, re-use screws (1). See service manual. Skip to COMPLETE. | |
| 3. | If installing reservoir brackets in conjunction with docking hardware, see Docking Hardware Instructions to complete installation. | |
| 4. | Repeat steps for opposite side of vehicle. |
COMPLETE
| 1. | Install saddlebags. See service manual. | |
| 2. | When saddlebag lids are open, check that no contact exists between reservoir, hoses and lid. |