Description (Quantity) | Part Number |
---|---|
Radio faceplate trim | Not Sold Separately |
1. | Using a 50:50 isopropyl alcohol/water solution, thoroughly clean the surface where the radio faceplate trim will be installed. | |
NOTICE Do not clean with denatured alcohol, mineral spirits, or other solvent products, or component damage may occur. (00411c) | ||
2. | Allow the surface to dry completely before continuing to install kit. | |
3. | Test the fit of the radio faceplate trim prior to removing adhesive backing. | |
4. | Remove the adhesive backing from the back of the radio faceplate trim. | |
5. | Open the auxiliary jack cap and feed it through the radio faceplate trim. | |
6. | See Figure 1. Position the radio faceplate trim and press firmly into place. | |
7. | Let the adhesive cure for at least 24 hours at no less than 60°F (16°C). |