1. | See Figure 1 and Figure 2. Stand behind the motorcycle. Place the front fork notches (1) into the front docking points (2) as shown in Figure 1 and Figure 2. | |||||||||||
2. | Pull the rotary latches (3) back into their rearmost position as shown in center view of Figure 1. Position the rear rotary latches over the rear docking points (4). Verify the latches and rack fit into the neck of the rear docking points as shown in the bottom view of Figure 1. This may require some gentle squeezing or spreading of the rack. |
Figure 1. H-D Detachables Solo Rack | ||||||||||
3. | Push downward and close the rotary latches (5) by pressing the latch lever as far forward as it goes as shown in the lower view of Figure 1. You hear a click when the latch is in place. If the latch does not easily close, do not force. Recheck alignment as described in Step 2 and Figure 2. NOTE After installing solo rack, pull upward to verify that it is locked into place. | |||||||||||
4. | To remove the solo rack, press the release button (A) shown in Figure 3. Pull the rotary latch lever back. Carefully lift the rear of the solo rack up. Pull the solo rack out of the front docking points. |
1 | Correct |
2 | Incorrect |
3 | Incorrect |
Kit | Item | Description (Quantity) | Part Number |
---|---|---|---|
Kit 53612-08 | 1 | Black detachable solo rack | Not Sold Separately |
2 | Load label | Not Sold Separately | |
3 | Stud, splined | Not Sold Separately | |
Kit 50300108 | 4 | Rotary latch assembly (2) | Not Sold Separately |
The following items are common in kit 50300108 | |||
5 | Button head screw | Not Sold Separately | |
6 | Flatwasher | 6827 | |
7 | Wave spring washer | 6828 | |
8 | Compression spring (not shown) | 53602-95 | |
A | Rotary latch release button |