TRIKE MUDFLAP KIT
J046682012-02-02
GENERAL
Kit Number
83833-09, 59600019
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
INSTALLATION
| 1. | See Figure 1. Center drilling template on the rear fender. Adjust template to the bottom edge of the fender and tape template to fender. | |||||||||||
| 2. | Center punch the two template drilling locations. NOTE Use caution to prevent damage to the tire when drilling the attachment holes for the mudflaps. | |||||||||||
| 3. | Use a 17/64 (.266) inch bit to drill the template holes. | |||||||||||
| 4. | See Figure 2. Install the mudflap using one stud, washer and nut in each fastening hole. Tighten to 6.8–13.6 N·m (5–10 ft-lbs). | |||||||||||
| 5. | Repeat Steps 1-4 for the opposite fender. | 
Figure 1. Attaching Template 
Figure 2. Mudflap Hardware  Figure 3. Installed Mudflap |
SERVICE PARTS
Figure 4. Service Parts: FLHTCUTG Mudflap Kit
Table 1. Service Parts
Item | Description (Quantity) | Part Number |
|---|---|---|
1 | Mudflap template | Not Sold Separately |
2 | Fender mudflap (2) | Not Sold Separately |
3 | Stud, 1/4-20 (4) | 8310 |
4 | Flat washer (4) | 6036 |
5 | Hex nut (4) | 7688 |