1. | 2014 and later Touring Models: See the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only) for a list of required parts or accessories for your model. | |
2. | Plug the headlamp connector of the LED headlamp into the wire harness connector block inside the headlamp bucket. | |
3. | See the service manual and follow the instructions to install the headlamp. | |
WARNING After installing seat, pull upward on seat to be sure it is locked in position. While riding, a loose seat can shift causing loss of control, which could result in death or serious injury. (00070b) | ||
4. | Refer to the service manual and follow the instructions given to connect the negative battery cable and install the seat. | |
5. | Test the headlamp for proper operation. Check the headlamp low beam for proper alignment. |
1 | Projector beam optic (typical) |
2 | Reflector optic (typical) |
3 | Centerline of low beam |
1 | Perpendicular line |
2 | Vertical line |
3 | 25 feet (7.6 meters) |
4 | Low beam lens centerline |
5 | Horizontal line - align top of left side of low beam (for vertical alignment) |
1 | Outline of high beam light pattern |
2 | Horizontal line |
3 | Intersection of horizontal and vertical lines |
1. | See Figure 4. Align the left side of the horizontal line of the low beam light pattern (3) with horizontal line (2) drawn on the wall. If necessary, adjust the headlamp position by following the adjustment procedure in the service manual. |
Figure 4. Alignment of Headlamp Low Beam |