CHROME FRONT ENGINE MOUNT BRACKET

J050462012-03-15

GENERAL

Kit Number

16205-10

Models

For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).

Additional Parts Required

Loctite^® 272 (98618-03)

WARNING

Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)

Kit Contents

Figure 1. Service Parts: Chrome Front Engine Mount Bracket

Table 1. Service Parts

Item	Description (Quantity)	Part Number
1	Engine mounting bracket, chrome	Not Sold Separately
2	Washer (2)	6615
3	Screw, 1-1/2 x 3/8 inch	94236-91T
4	Screw, 2 inch	94238-91T

NOTE

Kit 16213-10 contains a chrome stabilizer link and hardware to complement this kit.

INSTALLATION

1	Screw, 1-1/4 inch
2	Washer
3	Mounting bracket
4	Washer (2)
5	Screw, 2 inch
6	Screw, 1-1/2 inch

Figure 2. Remove Front Engine Mounting Bracket

1.	See Figure 2. Remove the right side screw (1) and washer (2) from the front stabilizer link. Save the screw and washer for reuse.
2.	Standing on the left side of the motorcycle, remove two hex head screws (5 and 6) and flat washers (4) to release the top engine mounting bracket (3) from the front cylinder head.
3.	Apply a few drops of Loctite 272 to the new bolts in the kit. From left side of the motorcycle use a three foot length of 2x4 wood as a pry bar. Insert the flat side of the wood between the left frame down tube and front cylinder. Use just enough pressure to move the motor slightly to the right and install the long screw (5) and washer (4) in the lower right side of the bracket. Remove the 2x4 wood and install the washer and the short screw (6) on the left side. Tighten bolts to 40.6–47.4 N·m (30–35 ft-lbs).
4.	Apply a few drops of Loctite to the screw (1) and install the screw and washer (2) to the stabilizer link and engine mounting bracket and tighten to 24.4–29.8 N·m (18–22 ft-lbs).