1. | See Figure 1. Remove the oil cooler guard (2) from the oil cooler (1) by using the Heat Gun (or equivalent) to apply heat to the top surface (3). Pull the guard away from the oil cooler and discard. | |
2. | Remove the three locknuts (5) fastening the oil cooler to the mounting bracket (4). | |
3. | Raise the oil cooler slightly to separate the studs on the underside of the oil cooler from the mounting bracket. | |
4. | Place the oil cooler cover (6) onto the oil cooler studs, between the oil cooler and the mounting bracket. | |
5. | Lower the oil cooler and cover into the holes in the mounting bracket. | |
6. | Place a locknut onto each stud. Line the oil cooler cover up squarely against the oil cooler, and tighten the locknuts to 9.1–12.4 N·m (80–100 in-lbs). |
1 | Oil Cooler |
2 | Guard |
3 | Area to Apply Heat |
4 | Mounting Bracket |
5 | Nut |
6 | Oil Cooler Cover |
Description (Quantity) | Part Number |
---|---|
Cover, oil cooler, chrome | 25700007 |