1. | Disconnect negative (-) battery cable. | |
2. | Loosen stock muffler clamps and remove nuts that attach mufflers to muffler support tube. Remove stock mufflers. Save all mounting hardware to install later. | |
3. | Install new kit mufflers using muffler clamps (purchased separately) and stock mounting hardware saved from Step 2. Do not tighten hardware at this time. NOTE Before tightening nuts that attach mufflers to muffler support tubes, make sure the front muffler is positioned as far forward in its brackets slot as possible. This will eliminate any possible contact between the mufflers. | |
4. | Tighten muffler clamp bolts to 61–81 N·m (45–60 ft-lbs). Tighten nuts that attach mufflers to muffler support tube snugly. | |
5. | Connect the negative (-) battery cable. |
Kit | Item | Description (Quantity) | Part Number |
---|---|---|---|
Kit 80794-10A | 1 | Muffler assembly, black, slash down, rear, coated | Not Sold Separately |
2 | Muffler assembly, black, slash down, front, coated | Not Sold Separately | |
3 | Clamp, wormdrive #48, (black) | 10800010 | |
4 | Heat shield, coated, rear, black (not shown) | 80868-10 | |
5 | Heat shield, coated, front, black (not shown) | 80865-10 |