0/0
SADDLEBAG HINGE COVER KIT
J056622014-03-28
GENERAL
Kit Number
90200915, 90201084
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Additional Parts Required
Certain international markets require amber reflectors. If your vehicle is equipped with amber reflectors, then separate purchase of reflectors (Part No. 67900066 and 67900068) is required.
Kit Contents
See Figure 2 and Table 1.
REMOVAL
  1. See Figure 1. Remove tether screws (1) to access hinge cover mounting screws (3). Save screws for installation.
  2. Hold hinge cover and remove screws (3) and hinge cover. Discard screws and hinge cover.
INSTALLATION
WARNING
Federal Motor Vehicle Safety Standard (FMVSS) 108 requires motorcycles to be equipped with rear and side reflectors. Be sure rear and side reflectors are properly mounted. Poor visibility of rider to other motorists can result in death or serious injury. (00336b)
NOTE
See Figure 1. Hinge cover mounting screws (3) are easily cross-threaded. Use care when installing.
1. See Figure 1. Install the hinge cover with screws (3). Tighten to 4.5–5.1 N·m (40–45 in-lbs).
2. Secure tether with screws (1). Tighten to 4.5–5.1 N·m (40–45 in-lbs).
3. Install reflectors 50–75 mm (2–3 in) below and centered with hinge cover:
a. Clean reflector mounting surface with an equal mixture of water and isopropyl alcohol. Allow to dry thoroughly.
b. Remove the adhesive backing from the reflector. Install the reflector on saddlebag. Hold in place for 10 seconds.
4. Repeat all steps for the other saddlebag.
1Screw (2)
2Tether
3Screw (3)
4Hinge cover
Figure 1. Hinge Cover Kit
SERVICE PARTS
Figure 2. Service Parts: Hinge Cover Kit
Table 1. Service Parts Table
Item
Description (Quantity)
Part Number
1
Hinge cover, right, black
90200916
Hinge cover, right, chrome
90201085
2
Hinge cover, left, black
90200917
Hinge cover, left, chrome
90201086
3
Screw (6)
2480
4
Reflector, red, left
59288-92
5
Reflector, red, right
59287-92