0/0
CIGARETTE LIGHTER KIT
J056702013-06-01
GENERAL
Kit Number
69200605
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Additional Parts Required
NOTE
This instruction sheet references service manual information. A service manual for your model motorcycle is required for this installation and is available from a Harley-Davidson dealer.
Kit Contents
See Figure 2 and Table 1.
ELECTRICAL OVERLOAD
NOTICE
It is possible to overload the vehicle's charging system by adding too many electrical accessories. If the combined electrical accessories operating at any one time consume more electrical current than the vehicle's charging system can produce, the electrical consumption can discharge the battery and cause damage to the vehicle's electrical system. (00211d)
WARNING
When installing any electrical accessory, be certain not to exceed the maximum amperage rating of the fuse or circuit breaker protecting the affected circuit being modified. Exceeding the maximum amperage can lead to electrical failures, which could result in death or serious injury. (00310a)
This cigarette lighter kit requires up to 5.0 amps more current from the electrical system.
REMOVAL
WARNING
To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before proceeding. (00251b)
  1. Follow the instructions in the service manual for the following procedures:
    1. Remove main fuse.
    2. Remove outer fairing.
    3. Remove right speaker enclosure
  2. See Figure 1. Disconnect power outlet connector [132] (16).
  3. Cut off 2-way connector as close to the connector as possible.
  4. Hold socket and loosen outer shell. Remove the power outlet and cap from inner fairing.
INSTALLATION
  1. Strip wires and crimp spade terminals to wires.
    2. NOTE
    It may be necessary to shift the location of cable straps to provide additional length in wire harness.
  2. Connect violet/blue wire (+) to center lug. Connect black wire (-) to sleeve lug.
  3. Install cigarette lighter socket from inner fairing side and tighten securely.
  4. Insert lighter element.
  5. Install main fuse and check operation.
  6. Follow the instructions in the service manual for the following procedures:
    1. Install right speaker enclosure
    2. Install outer fairing.
1CB connector
2P&A accessory
3Auxiliary audio input
4AM/FM radio antenna
5GPS antenna
6Left handlebar switches
7CB antenna
8Front fender tip lamp
9Main-to-fairing harness, left
10Heated hand grip power, if equipped (not visible)
11Run/stop switch
12Right handlebar switches (not visible)
13Main-to-fairing harness, right
14TGS
15Radio
16Power outlet
Figure 1. Inner Fairing Harness Connectors
SERVICE PARTS
Figure 2. Service Parts: Cigarette Lighter Kit
Table 1. Service Parts
Item
Description (Quantity)
Part Number
1
Cigarette lighter element
91808-89
2
Cigarette lighter socket
91812-89A
3
Terminal
72290-94