ENGINE GUARD KITS

J056972020-09-15

GENERAL

Kit Number

49184-09A

Models

This kit fits 2009 and later Touring models.

Additional Parts Required

WARNING

Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)

NOTE

This instruction sheet references service manual information. A service manual for your model motorcycle is required for this installation and is available from a Harley-Davidson Dealer.

Kit Contents

See Figure 1 and Table 1.

Installation

This kit is a direct replacement for the original equipment (OE) engine guard.

2009-2013 Models: See the service manual to remove and install engine guard. Install the upper screw and washer included in this kit instead of the OE screw and washer. Tighten the upper screw to 30–38 N·m (22–28 ft-lbs).

2014 and Later Models: See the service manual to remove and install the engine guard.

SERVICE PARTS

Figure 1. Service Parts: Engine Guard Kit

Table 1. Kit Contents P/N 49050-09A

Item	Description (Quantity)	Part Number
1	Engine guard	Not Sold Separately
2	Washer, ferrous heat treated	6116
3	Hex socket head cap screw	2708A