0/0
FLHRC SADDLEBAG KIT
J058132013-05-02
GENERAL
Kit Number
90201079
Models
For model fitment information, see the P&A retail catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Additional Parts Required
Genuine Harley-Davidson Leather Dressing (Part No. 98261-91V) can be purchased separately from any Harley-Davidson dealer.
WARNING
Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
Kit Contents
See Figure 2 and Table 1.
WARNING
Federal Motor Vehicle Safety Standard (FMVSS) 108 requires motorcycles to be equipped with rear and side reflectors. Be sure rear and side reflectors are properly mounted. Poor visibility of rider to other motorists can result in death or serious injury. (00336b)
WARNING
Do not exceed saddlebag weight capacity. Put equal weight in each bag. Too much weight in saddlebags can cause loss of control, which could result in death or serious injury. (00383a)
NOTE
Maximum saddlebag weight capacity is 4.55 kg (20 lb) per bag.
INSTALLATION
Remove Stock Saddlebag
  1. Open saddlebag.
  2. See Figure 1. Rotate each mounting stud (1) one-quarter turn counterclockwise. Remove studs and flat washers from grommets. Save hardware for installation.
  3. Remove saddlebag.
  4. Repeat for other side.
1Mounting stud
2Saddlebag guard
Figure 1. Remove Stock Saddlebag (Right Side Shown)
Install Reflectors
  1. See Figure 1. Clean saddlebag guard (2) throughly with an equal mixture of water and isopropyl alcohol. Allow to dry throughly.
  2. See Figure 2. Align the reflector (2) in the center of the saddlebag guard (A). Mark position with a grease pencil.
  3. Remove the adhesive backing from the reflector, align with markings and apply firmly.
  4. Repeat for other side.
  5. Allow reflector adhesive to set for 24 hours before exposing to water.
Install New Saddlebag
NOTE
Replace grommets (B) if torn or deteriorated.
  1. See Figure 2. Position saddlebag (1) on motorcycle aligning holes in grommets with attachment holes and rubber isolators on bottom of bag with saddlebag guard.
  2. Place flat washers (C) on mounting studs (D).
  3. Hold groove at end of stud horizontal and insert stud through grommet. When groove engages wire form spring in mounting bracket, turn stud clockwise one-quarter turn until it locks in place.
  4. Repeat for other side.
Saddlebag Care
Apply the Harley-Davidson Genuine Leather Dressing (purchased separately) according to the instructions.
SERVICE PARTS
Figure 2. Service Parts: FLHR Saddlebag Kit
Table 1. Service Parts, Detachable Saddlebag Kits
Item
Description (Quantity)
Part Number
1
Saddlebag assembly, right side (shown)
Not Sold Separately
Saddlebag assembly, left side
Not Sold Separately
2
Reflector (2)
69490-07
Items mentioned in instruction sheet but not included in kit:
A
Saddlebag guard (2)
B
Grommet (2)
C
Flat washer (2)
D
Mounting stud (2)