0/0
XL Chrome Master Cylinder and Clutch Bracket Kit
J058222013-06-10
GENERAL
Kit Number
41700190, 41700262
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Additional Parts Required
Installation of this kit will also require the use of Brake Pin Grease (Part Number 42820-04) and D.O.T. 4 Hydraulic Brake Fluid (Part Number 99953-99A), available separately from any Harley-Davidson dealer.
Ask your Harley-Davidson Dealer about the selection of hand control levers, and braided brake lines and clutch cables that are also available for these models. These items can be easily installed at the same time as this kit.
WARNING
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for your model motorcycle is required for this installation and is available from a Harley-Davidson Dealer.
WARNING
Brakes are a critical safety component. Contact a Harley-Davidson dealer for brake repair or replacement. Improperly serviced brakes can adversely affect brake performance, which could result in death or serious injury. (00054a)
WARNING
Do not use parts from single caliper repair kits (9/16 inch bore) on dual caliper models. Likewise, do not use parts from dual caliper repair kits (11/16 inch bore) on single caliper models. Using incorrect parts can cause brake failure, which could result in death or serious injury. (00278a)
Kit Contents
See Figure 1 and Table 1.
INSTALLATION
This kit is a direct replacement for the original equipment master cylinder and clutch bracket. Follow the instructions in the service manual to remove and install the original equipment front master cylinder and clutch bracket.
SERVICE PARTS
Figure 1. Service Parts: XL Chrome Master Cylinder and Clutch Bracket Kit
Table 1. Service Parts Table
Item
Description (Quantity)
Part Number
1
Master cylinder Assembly (chrome)
Not Sold Separately
2
  • Screw, flat (2)
2498
3
  • Cover, front master cylinder (chrome)
42318-04
4
  • Gasket kit, master cylinder
42805-04
5
  • Master cylinder, front, single disc (chrome)
Not Sold Separately
6
  • Set screw
Not Sold Separately
7
  • Front master cylinder pivot pin bolt (chrome)
41700252
8
  • Screw (2)
2472M
9
  • Washer (2)
6099
10
  • Clamp, half (chrome)
Not Sold Separately
11
  • Rebuild kit, front master cylinder, single disc, non-ABS
41700087
  • Rebuild kit, front master cylinder, single disc, ABS
41700084
12
  • Front master cylinder pivot pin nut
41700253
13
Screw (2)
2472M
14
Washer (2)
6099
15
Half clamp, clutch (chrome)
Not Sold Separately
16
Clutch lever bracket (chrome)
Not Sold Separately
17
Brake line gasket (not shown) (2)
41756-08