EXHAUST SLIDER GUARD
J058352015-08-24
GENERAL
Kit Number
49000067
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Installation Requirements
WARNINGRider and passenger safety depend upon the correct installation of this kit.
If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation.
Improper installation of this kit could result in death or serious injury. (00308b)
Kit Contents
This kit contains no service parts.
INSTALLATION
- See Figure 1. Loosen worm drive clamp (2).
- Slide guard assembly (3) onto muffler (1) until joint between muffler tip and muffler is just hidden by the rear edge of guard.
- Push the guard halves together to create the smallest gap at the top.
- Rotate clamp so screw is at approximately the 8 o'clock position (arrow). Tighten securely.
| 1 | Muffler |
| 2 | Screw clamp |
| 3 | Guard |
Figure 1. Install Guard