Item | Qty | Description | Part No. | Notes | |
---|---|---|---|---|---|
1 | 1 | AM/FM/WB Hidden antenna kit (includes items 2-9) | 76000513 | ||
2 | 1 | Antenna, AM/FM/WB (includes items 3-4) | Not sold separately | ||
3 | 1 | Fuse, mini type, 2 Amp (gray) | 54305-98 | ||
4 | 1 | Foam tape, two-side adhesive | Not Sold Separately | ||
5 | 1 | Alcohol cleaning packet | Not sold separately | ||
6 | 8 | Wire retainer, adhesive b | 69200342 | ||
7 | 10 | Cable strap | 10065 | ||
8 | 1 | Thread protector cap, antenna ba | 25700109 | ||
9 | 1 | Plug, fascia antenna hole | 59749-06 | ||
Items mentioned in text but not included in kit: | |||||
A | 1 | Black antenna ground wire | |||
B | 1 | Red antenna power wire | |||
C | 2 | Antenna element | |||
D | 2 | Antenna end |
1. | Remove main fuse. See service manual. |
1. | Remove windshield. See service manual. | |
2. | Remove outer fairing. See service manual. | |
3. | Remove headlight. See service manual. |
1. | See Figure 2 or Figure 3. Clean the antenna mounting surface under the windshield vent with the alcohol pad (see Figure 1 , Item 5). Mount the antenna as shown in the correct figure. | |
2. | Plug the antenna harness connector into P&A Power Accessory connector [299] (2). | |
3. | For Vehicles with Accessory Amplifier Installed: Separate purchase and installation of the Accessory Power Y-Connector (Part No. 69200921) is required. | |
4. | Unplug the original equipment (OE) AM/FM connector. Plug in the antenna connector (3). Plug the OE AM/FM connector into the antenna connector. | |
5. | Route the antenna wires around speaker pods. Secure with wire retainers and cable straps. Clean wire retainer mounting surfaces with the alcohol pad before adhering the retainer. | |
6. | See Figure 1. FLHX Models: Remove the grommet from the antenna clearance hole in the rear fender fascia. Install the hole plug (9) from the kit. ALL Models: Remove the OE AM/FM antenna mast from the rear of the vehicle. Install the antenna thread protector (8) over the antenna base. |
1. | Install main fuse. See service manual. | |
2. | See . Check for antenna function. The red LED on the antenna body should illuminate with the ignition switch in the ACCY or IGN position. If it does not, check the inline fuse (3) on the red antenna power wire or the vehicle accessory fuse. | |
3. | NOTE Installation of the hidden antenna could result in a slight reduction of AM signal reception in certain urban and rural locations. | |
4. | See the service manual to install the outer fairing, windshield, headlight and main fuse. |
1 | Fuse holder |
2 | P&A power accessory harness |
3 | Antenna connector |
4 | Primary mounting location |
1 | Fuse holder |
2 | P&A power accessory harness |
3 | Antenna connector |
4 | Primary mounting location |
5 | Secondary mounting location |