1 | Speaker enclosure |
2 | Fairing harness anchor |
3 | Speaker connector |
4 | CB connector |
5 | Fairing support bracket |
6 | Screw, hex head socket, 5/16-18 x 3/4 in (19 mm) long (3) |
7 | Upper support bracket |
8 | Screw, hex socket, 1/4-20 x 1/2 in (13 mm) long (2) |
9 | Screw, hex socket, 1/4-20 x 3/4 in (19 mm) long (3) |
10 | DO NOT remove these screws (13) |
11 | Speaker grille |
12 | Screw, TORX, #10 x 3/8 in (10 mm) long (3) |
1. | Install a correct speaker grille from the kit into each side of the inner fairing. Secure with three TORX screws ( Figure 1 , Item 12) removed earlier. Tighten to: Torque: 1–1.4 N·m (9–13 in-lbs) TORX pan head screw with lock patch | |
2. | For Kit 76000623 only: Remove adhesive liner from emblem and assemble to grille. Verify proper orientation of the bar and shield before assembly. | |
3. | Secure the lower portion of the enclosure to the fairing support bracket (5) with three hex head socket screws (6) removed earlier. Tighten to: Torque: 27.1–32.5 N·m (20–24 ft-lbs) Hex socket screw | |
4. | Secure the enclosure to the upper support bracket with two hex socket screws (8). Tighten to: Torque: 5.4–6.8 N·m (48–60 in-lbs) Hex socket button head screw with attached lockwasher | |
5. | Repeat steps 2-4 with the remaining enclosure. | |
6. | Mate the speaker and power outlet connectors. Secure the harness anchors to the speaker enclosures. | |
7. | Left side only, CB-equipped models: Plug in the CB connector [184] and CB antenna. See the service manual. |
1. | See the service manual to install the main fuse. | |
2. | Turn the ignition ON, but do not start the motorcycle. NOTE Before installing outer fairing, check that speakers are operating correctly. Understand that buzzing, squeaks and rattles may be heard until outer fairing is installed. | |
3. | Refer to the PREMIUM SOUND SYSTEM section of the owner's manual and turn the radio ON. Make sure that all speakers are working and front/rear fader function is operating correctly. If not, check speaker wiring. | |
4. | See the service manual to install the outer fairing and windshield. | |
5. | Install seat. After installing seat, pull up on the seat to be sure it is secure. See the service manual to install the seat. |
Item | Description (Quantity) | Part Number |
---|---|---|
1 | Grille (2) (Kit 76000623) | Not Sold Separately |
2 | Medallion (2) | 14100423 |
3 | Grille (2) (Kits 76000685, 7600686, 7600687) | Not Sold Separately |