WOUNDED WARRIOR SISSYBAR FLAG MOUNTING KIT
J062502015-03-15
GENERAL
Kit Number
61400374
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
NOTE
Flags are not intended for highway use. The construction of these flags will not hold up to the wind speeds seen at highway speeds. These flags are designed for parade use only.
Kit Contents
Table 1. Kit Contents
Description (Quantity) | Part Number |
|---|---|
Cable strap (4) | 10006 |
Mast, flag | Not Sold Separately |
Retainer, flag mast | Not Sold Separately |
Flag | 61400376 |
INSTALLATION
| 1. | Remove sissybar pad if necessary. | |
| 2. | See Figure 1. Hold flag mast in position against the sissybar. | |
| 3. | Fasten two cable straps as shown, with latch ends of cable straps against inside of the flag mast. | |
| 4. | Pull cable straps as snug as possible to secure the flag mast to sissy bar, then trim cable strap ends. NOTE Only two cable straps are required to secure the flag mast. Fasten on cable strap through sissybar, then trim the cable strap ends. |  Figure 1. Mast Mounted on Outside Edge of Sissy Bar  Figure 2. Mast Mounted on Inside Edge of Sissy Bar |