SCREAMIN' EAGLE CVO 4-INCH TOURING MUFFLERS (BLACK)

J062972015-09-02

GENERAL

Kit Number

64900514

Models

For model fitment information, see the P&A retail catalog or the Parts and Accessories section of www.harley-davidson.com (English only).

Installation Requirements

Proper installation of this kit requires the separate purchase of two muffler clamps (H-D Part No. 65296-95A).

This kit does not contain muffler end caps. End caps can be purchased separately from a Harley-Davidson dealer.

WARNING

Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)

NOTE

This instruction sheet refers to service manual information. A service manual for your year/model motorcycle is required for this installation. One is available from a Harley-Davidson dealer.

Kit Contents

This kit consists of two mufflers and these instructions. There are no service parts available for this kit.

Product Information

Noise Emission Warranty

Harley-Davidson warrants that these mufflers, at the time of sale, meet all applicable United States E.P.A. Federal Noise and Emissions standards. This warranty extends to the original purchaser for purposes other than resale, and to all subsequent buyers. Direct warranty claims to an authorized Harley-Davidson dealer.

Tampering Prohibition

Federal law prohibits any modifications to this exhaust system which cause the motorcycle to exceed Federal noise standards. Use of a motorcycle with such a modified exhaust system is also prohibited.

NOTE

To avoid penalties under state and local ordinances, repair or replace this product if motorcycle noise increases significantly through use.

Preparation

WARNING

To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before proceeding. (00251b)

NOTE

WITH security siren: With security fob present, turn ignition switch ON. See the service manual. Disarm security system. Turn ignition switch OFF. IMMEDIATELY remove the main fuse.
WITHOUT security siren: See the service manual. Remove main fuse.

Installation

NOTE

Install end caps on mufflers before installing mufflers on vehicle. See instructions included with the end cap kit.

1.	Remove saddlebags per the service manual.
2.	See Figure 1. Loosen original equipment (OE) muffler clamp (1).
3.	See Figure 2. Remove and retain OE bolts (1) and lockwashers (2).
4.	Remove OE muffler. Discard muffler and clamp.
5.	Install new muffler clamp on inlet end of new muffler. Slide muffler onto exhaust pipe.
6.	Secure rear of muffler to sliding bracket with OE bolts and lockwashers. Do not fully tighten bolts now.
7.	Position sliding bracket so rubber mount (3) is at center of bracket.
8.	Tighten bolts (1) to 19–24.4 N·m (14–18 ft-lbs).
9.	See Figure 1. Position front muffler clamp as shown so clamp bolt and nut are vertical.
10.	Tighten clamp nut to 51.5–58.3 N·m (38–43 ft-lbs).
	NOTICE Wipe all fingerprints off of exhaust system components after installation and before starting engine. Oil from hands can leave permanent marks on exhaust system finish. (00346a)
11.	Wipe exhaust system clean.
12.	Repeat steps 2-11 for the opposite side.
13.	Start engine and check for exhaust leaks.
14.	Install saddlebags per the service manual.

1	Muffler clamp

Figure 1. Front Muffler Clamp

1	Bolt, 5/16-18 x 5/8 inch (4)
2	Lockwasher (4)
3	Rubber mount

Figure 2. Rear Muffler Mount