CYLINDER BASE COVER KIT

J063092016-08-16

GENERAL

Kit Number

25700632

Models

For the most up-to-date model fitment information see the product label or www.harley-davidson.com.

WARNING

Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)

NOTE

This instruction sheet references Service Manual information. A Service Manual for your model motorcycle is required for installation. One is available from a Harley-Davidson Dealer.

Kit Contents

See Figure 2 and Table 1.

There are no Service Parts available with this kit.

INSTALLATION

1.	See Figure 1. See the service manual. Disassemble shifter linkage assembly (1).
2.	Remove the crankcase screw (2) centered between the cylinders as shown. Discard screw.
3.	See Figure 2. Install rubber caps (3) over remaining engine case hex flange screws. These screws are covered by the installed cylinder base cover.
4.	Install the cylinder base cover using button head cap screw (4). Tighten screw to 20–26 N·m (15–19 ft-lbs).
5.	See Figure 1. See the service manual. Reassemble the shifter linkage assembly (1).

1	Shifter linkage assembly
2	Crankcase screw

Figure 1. Disassemble shifter linkage. Remove crankcase screw

SERVICE PARTS

Figure 2. Service Parts: Cylinder Base Cover Kit

Table 1. Service Parts Table

Item	Description (Quantity)	Part Number
1	Cylinder base cover	Not Sold Separately
2	Spacer, cylinder base cover	Not Sold Separately
3	Cap, rubber (2)	Not Sold Separately
4	Screw, button head Torx, 5/16-18 x 3-1/2 in	Not Sold Separately