1. | Remove original equipment (OE) trim ring and mounting screw. Save mounting screw for later installation. | |
2. | Remove rubber bumpers from OE trim ring and install on new trim ring. | |
3. | See Figure 1. Hook new trim ring (2) onto headlamp nacelle. Ensure rubber gasket seats in trim ring correctly. | |
4. | Install OE mounting screw (1) in trim ring. Tighten. Torque: 2.8–3.6 N·m (25–32 in-lbs) |
1 | OE mounting screw |
2 | Trim ring |