BULLET BLACK DIRECTIONAL BAR KIT

J065822017-11-07

GENERAL

Kit Numbers

67800982

Models

For model fitment information, see the P&A retail catalog or the Parts and Accessories section of www.harley-davidson.com (English only).

Tools and Supplies Required

WARNING

Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)

NOTE

This instruction sheet refers to service manual information. A service manual for this year/model motorcycle is required for this installation and is available from a Harley-Davidson dealer.

Electrical Overload

NOTICE

It is possible to overload the vehicle's charging system by adding too many electrical accessories. If the combined electrical accessories operating at any one time consume more electrical current than the vehicle's charging system can produce, the electrical consumption can discharge the battery and cause damage to the vehicle's electrical system. (00211d)

WARNING

When installing any electrical accessory, be certain not to exceed the maximum amperage rating of the fuse or circuit breaker protecting the affected circuit being modified. Exceeding the maximum amperage can lead to electrical failures, which could result in death or serious injury. (00310a)

At 13.5V, the current draw is 169mA. The current draw may vary up to 241mA dependent on batter voltage.

PREPARATION

WARNING

To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before proceeding. (00251b)

Remove main fuse. See the service manual.

REMOVAL

Remove rear lamp lens. See the service manual.

See Figure 1. Disconnect turn signal connectors (3) and (4) and feed them through the fender.

1	Tail lamp [93]
2	Rear fender tip lamp [45]
3	Left rear turn signal [19]
4	Right rear turn signal [18]
5	Rear fender lights harness in circuit board [94]

Figure 1. Rear Fender Lights

See Figure 2. Remove the turn signal lamp fasteners (1) and release the turn signal wires from the retention clips (2) from the underside of the rear fender (3).

1	Turn signal fasteners (2)
2	Retention clips (2)
3	Rear fender
4	Routing hole

Figure 2. Under Fender

Pull the old turn signal lamp wires through the hole in the fender to free the original lightbar from the motorcycle. Save mounting hardware and lenses for reassembly. The lightbar may be discarded.

INSTALLATION

1.	Route the wires on the new lightbar through the fender.
2.	Install the lightbar. See service manual.
3.	Capture the conduit in the cable clip under the fender.

RETURN TO SERVICE

NOTE

Verify that the ignition key switch is in the OFF position before installing the main fuse or attaching the negative battery cable.

Install the main fuse. See service manual

WARNING

Be sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury. (00316a)

BCM Programming Process

2.	See service manual. Follow procedure for clearing BCM codes.
3.	Program the BCM. The BCM can self-learn if LED turn signals are installed when the Hazards are active after the LED installation. Activate hazards for at least 20 seconds (or to a count of 12 flashes). After 12 flashes of the Hazards the setting is updated in the BCM.
4.	Turn the ignition key switch to IGNITION, but do not start the vehicle. Test lights and verify turn, brake and run lights operate as expected.
5.	See service manual. Verify that there are no BCM codes. If codes display, see the service manual. Follow procedure for clearing BCM codes.
6.	Position the tail lamp lens and install the screws. Tighten. Torque: 4.5–5.4 N·m (40–48 in-lbs) NOTE Over tightening screws can crack the lens.