TRANSMISSION ACCENT COVERS
J067482019-08-21
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) | Time |
|---|---|---|---|
61301071, 61301078 | Safety Glasses, Flathead Screwdriver, Isopropyl Alcohol |   | 1 hour |
(1) Only simple tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Transmission Accent Covers
Table 2. Kit Contents: Transmission Accent Covers
 | Item | Qty | Description | Part No. | Notes |
|---|---|---|---|---|---|
 | Transmission Accent Covers Kit 61301071 | ||||
| 1 | Cover, Large, Carbon Fiber | 61301072 | ||
| 2 | Cover, Small, Carbon Fiber | 61301073 | ||
| 3 | Cover, Left Side, Carbon Fiber | 61301074 | ||
| Transmission Accent Covers Kit 61301078 | ||||
| 1 | Cover, Large, Black w/ Highlights | 61301079 | ||
| 2 | Cover, Small, Black w/ Highlights | 61301080 | ||
| 3 | Cover, Left Side, Black w/ Highlights | 61301081 | ||
NOTE
Verify all contents are present in the kit before installing or removing items from vehicle.
GENERAL
Models
For model fitment information, please see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Ensure you are using the most current version of the instruction sheet which is available at: www.harley-davidson.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNINGRider and passenger safety depend upon the correct installation of this kit.
If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation.
Improper installation of this kit could result in death or serious injury. (00308b)
REMOVE
| 1. | Remove Original Equipment (OE) insert from lower transmission housing. a. Use a flathead screwdriver to pry outward on bottom edge of cover. b. Remove all tape and adhesive residue from transmission cover. |
INSTALLATION
| 1. | Thoroughly clean area with a 50:50 mix of isopropyl alcohol and water. Allow to dry completely. | |
| 2. | Remove tape protecting adhesive pads on the inside of decorative insert. | |
| 3. | Visually align decorative insert covers to mating component. a. Align cover (2) with alignment notch. b. Press firmly in fastener area to secure. | |
| 4. | Hold for 30 seconds. NOTE Wait 24 hours before exposure to water, temperature change or operating vehicle. Adhesive will fully cure after 72 hours at room temperature. |