TANK STRAP
J067502019-08-21
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) | Time |
|---|---|---|---|
61301076 | Safety Glasses, Isopropyl alcohol |   | 1 hour |
(1) Only simple tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Tank Strap
Table 2. Kit Contents: Tank Strap
 | Item | Qty | Description | Part No. | Notes |
|---|---|---|---|---|---|
 | 1 | Tank Strap | Not sold separately |
NOTE
Verify all contents are present in the kit before installing or removing items from vehicle.
GENERAL
Models
For model fitment information, please see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Ensure you are using the most current version of the instruction sheet which is available at: www.harley-davidson.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNINGRider and passenger safety depend upon the correct installation of this kit.
If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation.
Improper installation of this kit could result in death or serious injury. (00308b)
INSTALL
NOTE
Install panels when ambient temperature is 16 °C (61 °F) or above.
| 1. | See Figure 1. Thoroughly clean area with a 50:50 mix of isopropyl alcohol and water. Allow to dry completely. | |
| 2. | Remove tape protecting the adhesive pads (2) on the inside of the tank strap. | |
| 3. | See Figure 2. Install tank strap to tank. a. Start at base of tank. b. Continue working up the tank. | |
| 4. | Press firmly on top surface of cover. | |
| 5. | Hold for 30 seconds. NOTE Wait 24 hours before exposure to water, temperature change or operating vehicle. Adhesive will fully cure after 72 hours at room temperature. |
| A | Install starting point |
Figure 2. Tank Strap Installation