80GRIT™ FOOTBOARD KIT - RIDER

J067852020-01-14

GENERAL INFORMATION

Table 1. General Information

Kits	Suggested Tools	Skill Level⁽¹⁾	Time
50501602, 50501604	Safety Glasses, Torque Wrench		1 hour

(1) Tightening to torque value or other moderate tools and techniques required

KIT CONTENTS

Figure 1. Kit Contents: Rider Footboard Components

Table 2. Kit Contents: Rider Footboard Components

Item	Qty	Description	Part No.	Notes
1	4	Screw	10500161	Torque: 6.8 - 9 Nm (60 - 80 in-lbs)
2	4	Nut	7716
3	2	Footboard bracket, front, rider	50501793
4	2	Footboard, black, rider	50501626	Kit 50501604
4	2	Footboard, raw, rider	50501625	Kit 50501602
5	2	Wear plate	50501661
6	4	Screw, wear plate	10200659	Torque: 2.03 Nm (18 in-lbs)

NOTE

Verify all contents are present in the kit before installing or removing items from vehicle.

GENERAL

Models

For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).

Verify that the most current version of the instruction sheet is used. It is available at: www.harley-davidson.com/isheets

Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.

Installation Requirements

WARNING

Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)

NOTE

This instruction sheet references service manual information. A service manual for the year and model motorcycle is required for this installation and is available from:

A Harley-Davidson dealer.
H-D Service Information Portal, a subscription-based access available for most 2001 and newer models. For more information see Frequently ask questions about subscriptions.

LOCTITE 243 MEDIUM STRENGTH THREADLOCKER AND SEALANT (BLUE) (99642-97)

PREPARE

Set motorcycle upright. See Secure the Motorcycle for Service in the service manual.

REMOVE

1.	Remove Original Equipment (OE) pivot screw nuts and pivot screws. See the service manual.
2.	Remove OE footboards. See the service manual.
3.	NOTE Save screw for install. Remove OE forward bracket. See the service manual.

INSTALL

1.	Clean and inspect footboard brackets. Replace if worn, rusted or damaged.
2.	See Figure 1. Install footboard. a. Install new front rider footboard bracket (3) using OE fasteners. b. Install new shoulder bolts (1) and footboard (4). c. Tighten front rider footboard bracket (3) fastener. See the service manual. d. Apply threadlocker and install nut (2). Tighten. Torque: 6.8–9 N·m (60–80 in-lbs)
3.	Check that foorboard pivots freely on screws (1).
4.	Repeat for opposite side.

NOTE

Avoid contacting chrome surfaces with abrasive materials (stones, sand, etc.) as damage will result.

REPLACE WEAR PLATE

1.	Remove screws (6).
2.	Replace wear peg (5).
3.	Apply threadlocker to threads of screws and install. Tighten. Torque: 2 N·m (18 in-lbs)