CARBON FIBER TAIL SECTION COWL, AMP
J068022021-01-04
GENERAL INFORMATION
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) | Time |
|---|---|---|---|
61301070 | Safety Glasses |  |
(1) Only simple tools and techniques required
KIT CONTENTS
| A | Thumb position during install and removal |
Figure 1. Kit Contents: Carbon Fiber Tail Section Cowl
This kit contains one carbon fiber passenger seat cover. There are no service parts available for this kit.
GENERAL
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Verify that the most current version of the instruction sheet is used. It is available at: www.harley-davidson.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNINGRider and passenger safety depend upon the correct installation of this kit.
If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation.
Improper installation of this kit could result in death or serious injury. (00308b)
INSTALL
| 1. | Raise seat. See owner's manual. | |
| 2. | See Figure 1. Install cowl. a. Align rear tab with slot at rear of seat. b. With thumbs placed near position A pull straps outward just enough to allow front of cowl to pass over seat. c. Slide cowl along seat into position while engaging tab at rear. d. Join straps under seat base and bond hook and loop material. | |
| 3. | Lower seat. Pull up on seat to verify that it is secure. See owner's manual. |