80GRIT™ PASSENGER FOOTPEGS

941000382020-01-14

Table 1. General Information

Kits	Suggested Tools	Skill Level⁽¹⁾	Time
50501603, 50501605	Safety Glasses, Torque Wrench		1 hour

(1) Tightening to torque value or other moderate tools and techniques required

KIT CONTENTS

Figure 1. Kit Contents: Footpeg Kit

Table 2. Kit Contents: Footpeg Kit

Item	Qty	Description	Part No.	Notes
1	2	Footpeg assembly, raw	50501619	Kit 50501603
1	2	Footpeg assembly, black	50501620	Kit 50501605
2	2	Screw	2708A	28.5 N·m (21.0 ft-lbs)
3	8	Screw	10200913	1.13–1.36 N·m (10–12 in-lbs)
4	2	Footpeg trim	Not sold separately

NOTE

Verify all contents are present in the kit before installing or removing items from vehicle.

GENERAL

Models

For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).

Verify that you are using the most current version of the instruction sheet which is available at: www.harley-davidson.com/isheets.

Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.

Installation Requirements

WARNING

Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)

NOTE

This instruction sheet references service manual information. A service manual for your model motorcycle is required for this installation and is available from a Harley-Davidson dealer.

Proper installation of this kit requires Loctite 243 Threadlocker and Sealant - Blue (Part No. 99642-97).

REMOVE

1.	Remove hardware fastening existing footpegs to footpeg support. Save hardware for installation. See service manual.
2.	Save all hardware for installation of new footpegs.
3.	Remove existing footpegs and spring washers. Save spring washers for installation.

INSTALL

1.	See Figure 2. Install spring washer (1) as shown and mount end of the footpeg into footpeg support slot (3).
2.	Secure each footpeg and spring washer with hardware removed earlier. See service manual.
3.	See Figure 1. Adjust orientation: a. Remove four screws (3) and foot peg trim (4). b. Loosen screw (2) just enough to allow rotation of footpeg. c. Rotate to desired orientation. d. Tighten adjustment screw (2). Torque: 28.5 N·m (21.0 ft-lbs)
4.	Apply a drop of threadlocker to each screw (3).LOCTITE 243 MEDIUM STRENGTH THREADLOCKER AND SEALANT (BLUE) (99642-97)
5.	Install trim (4) and four screws (3). Tighten. Torque: 1.13–1.36 N·m (10–12 in-lbs)

WARNING

Footrests must fold up and toward rear of motorcycle if struck. Failure to set footrests to fold up and back could result in death or serious injury. (00366a)

1	Spring washer
2	Spring washer straight edge
3	Footpeg support slot

Figure 2. Footpeg Spring Washer Installation