REAR BRAKE LEVER

941001052023-08-14

GENERAL INFORMATION

Table 1. General Information

Kits	Suggested Tools	Skill Level⁽¹⁾
41600326, 41600348, 41600370	Safety glasses, Torque wrench

(1) Tightening to torque value or other moderate tools and techniques required

KIT CONTENTS

Figure 1. Kit Contents: Rear Brake Lever

Table 2. Kit Contents: Rear Brake Lever Kit

	Verify that all contents are present in the kit before installing or removing items from vehicle.
	Item	Qty	Description	Part No.	Notes
	1	1	Rear brake lever	Not sold separately
Items mentioned in text, but not included in kit
	A	1	Original Equipment (OE) screw
	B	1	OE washer
	C	1	OE clevis pin

GENERAL

Models

For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.

Verify that the most current version of the instruction sheet is used. It is available at: h-d.com/isheets

Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.

Installation Requirements

WARNING

Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)

NOTE

This instruction sheet references service manual information. A service manual for the year and model motorcycle is required for this installation and is available from:

A Harley-Davidson dealer.
H-D Service Information Portal, a subscription-based access available for most 2001 and newer models. For more information see Frequently ask questions about subscriptions.

PREPARE

If removing right side footrest bracket or brake pedal

1.	Remove main fuse. See service manual.
2.	Remove exhaust. See service manual.
3.	Remove footpeg assembly. See service manual.
4.	Remove rear brake master cylinder from bracket. See service manual.
5.	Remove brake pedal. See service manual.

REMOVE

Remove OE brake lever. See service manual.

INSTALL

See Figure 1. Install new brake lever (1).

a. Install OE clevis pin (C).

b. Install OE screw (A) and washer (B). Tighten.

Torque: 17–21 N·m (13–15 ft-lbs)

c. 41600348, 41600370: Requires separate purchase of brake pedal pad.

COMPLETE

If right side footrest bracket or brake pedal was removed

1.	Install brake pedal. See service manual.
2.	Install rear brake master cylinder on bracket. See service manual.
3.	Install footpeg assembly. See service manual.
4.	Install exhaust system. See service manual.
5.	Install main fuse. See service manual.