REVOLUTION MAX - VELOCITY STACK
941001882022-03-07
GENERAL INFORMATION
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) |
|---|---|---|
29400433, 29400453 | Safety Glasses, Torque Wrench |  |
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Revolution Max - Velocity Stack
Table 2. Kit Contents: Revolution Max - Velocity Stack
 | Verify that all contents are present in the kit before installing or removing items from vehicle. | ||||
|---|---|---|---|---|---|
Item | Qty | Description | Part No. | Notes | |
 | 1 | 1 | Screw, flange, M6 | 10200899 | |
| 2 | 2 | Screw, flange, M12 | 10201013 | |
| 3 | 1 | Velocity stack | Not sold separately | |
GENERAL
Models
For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.
Verify that the most current version of the instruction sheet is used. It is available at: h-d.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNINGRider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for the year and model motorcycle is required for this installation and is available from:
- A Harley-Davidson dealer.
- H-D Service Information Portal, a subscription-based access available for most 2001 and newer models. For more information see Frequently ask questions about subscriptions.
REMOVE
| 1. | See Figure 2. Remove Original Equipment (OE) right side valley cover. a. Pull cover (1) off and discard. | |
| 2. | See Figure 3. Remove right side valley cover bracket. a. Remove small screw (2) and discard. b. Remove large screws (1) and discard. c. Remove bracket (3). |
| 1 | Cover |
Figure 2. Right Side Valley Cover
| 1 | OE Large screw (2) |
| 2 | OE Small screw |
| 3 | Bracket |
Figure 3. Bracket
INSTALL
| 1. | See Figure 4. Install velocity stack (3). | |
| 2. | Install small screw (1). Tighten. Torque: 5.8–7.9 N·m (51–70 in-lbs) Small screw | |
| 3. | Install large screws (2). Tighten. Torque: 108–119 N·m (80–88 ft-lbs) Large screw |
| 1 | Small screw |
| 2 | Large screw (2) |
| 3 | Velocity stack |
Figure 4. Velocity Stack