CHIN SPOLIER KIT
941002592022-02-22
GENERAL INFORMATION
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) |
|---|---|---|
57200347 | Safety Glasses, Torque Wrench |  1 Dark wrench
|
(1) Only simple tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Chin Spoiler Kit
Table 2. Kit Contents: Chin Spoiler Kit
 | Verify that all contents are present in the kit before installing or removing items from vehicle. | ||||
|---|---|---|---|---|---|
Item | Qty | Description | Part No. | Notes | |
 | 1 | 1 | Right chin spoiler | Not sold separately | |
| 2 | 1 | Left chin spoiler | Not sold separately | |
GENERAL
Models
For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.
Verify that the most current version of the instruction sheet is used. It is available at: h-d.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNINGRider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for the year and model motorcycle is required for this installation and is available from:
- A Harley-Davidson dealer.
- H-D Service Information Portal, a subscription-based access available for most 2001 and newer models. For more information see Frequently ask questions about subscriptions.
REMOVE
| 1. | Remove right and left side OE chin spoiler. See service manual. a. Save OE screws for later use. |
INSTALL
| 1. | See Figure 2. Install right chin guard (1). a. See Figure 3. Make sure mounting tabs are attached to center chin guard properly. | |
| 2. | See Figure 2. Install OE screws (2). Tighten. Torque: 7–9 N·m (62–80 in-lbs) |
| 1 | Chin guard |
| 2 | Screw (2) |
Figure 2. Chin Guard Installed
| 1 | Mounting tab |
Figure 3. Mounting Tabs