SIREN DISC BRAKE LOCK

941002872022-01-17

GENERAL INFORMATION

Table 1. General Information

Kits	Suggested Tools	Skill Level⁽¹⁾
92800012	N/A

(1) Only simple tools and techniques required

KIT CONTENTS

Figure 1. Kit Contents: Siren Disc Brake Lock

Table 2. Kit Contents: Siren Disc Brake Lock

Verify that all contents are present in the kit before installing or removing items from vehicle.
Item	Qty	Description	Part No.	Notes
1	2	Key	Not sold separately
2	1	Reminder cord
3	1	Hex wrench
4	1	Siren disc lock

GENERAL

Alarm Information

NOTE

The siren is loud and has a decibel rating of 120.

There is no on-off switch. When arming or disarming the alarm (1 beep = alarm activated) and (2 beeps = alarm deactivated).

When transporting disc brake lock, deactivate alarm so that vibration or motion will not cause alarm to sound.

When alarm is activated by motion or excessive vibration, it will give 5 medium beeps.

The alarm will go into sleep mode. If motion continues to be detected, alarm will give 5 loud beeps and then a 120 dB siren will activate for 10 seconds and stop.

If movement continues after 10 seconds, alarm will repeat sequence of 5 loud beeps and 120 dB siren for 10 seconds.

If there is continued movement, alarm will give 5 loud beeps and then a 120 dB siren will activate for 10 seconds and stop.

Perform steps 1 through 5 until no movement is detected or key is inserted back into cylinder to open and turn off alarm. See LOCKING WITH ALARM ACTIVATED or LOCKING WITHOUT ALARM ACTIVATED.

Models

For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.

Verify that the most current version of the instruction sheet is used. It is available at: h-d.com/isheets

Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.

Installation Requirements

WARNING

Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)

NOTE

This instruction sheet references service manual information. A service manual for the year and model motorcycle is required for this installation and is available from:

A Harley-Davidson dealer.
H-D Service Information Portal, a subscription-based access available for most 2001 and newer models. For more information see Frequently ask questions about subscriptions.

INSTALL BATTERY

1.	See Figure 2. Remove hex screw (7) using hex wrench (8).
2.	Remove back cover plate (4).
3.	Remove alarm module (5) from lock body (6).
4.	Remove battery cover (2).
5.	Install battery (3) into alarm module (5).
6.	Perform procedure in reverse to assemble.

1	Key
2	Battery cover
3	Battery
4	Back cover plate
5	Alarm module
6	Lock body
7	Hex screw
8	Hex wrench

Figure 2. Lock Assembly

LOCKING WITH ALARM ACTIVATED

1.	See Figure 2. Insert key (1), rotate clockwise and remove.
2.	See Figure 3. Install wheel lock (1) onto brake disc. a. See Figure 1. Install reminder cord (2). b. See Figure 4. Install one loop end (1) to end of grip. c. Install other loop end (1) to wheel lock key cylinder.
3.	Press top of key cylinder down approximately half-way and listen for one beep.
4.	Continue to press until it clicks into place. a. Wait five seconds for another beep. b. This indicates disc lock is both armed and locked.
5.	If two beeps are heard: a. Allow key cylinder to go upwards till it stops. b. Slowly press top of key cylinder back down half-way and listen for one beep. c. If this is heard, continue to push all the way down until it clicks. d. The disc is now locked.

LOCKING WITHOUT ALARM ACTIVATED

1.	See Figure 2. Insert key (1), rotate clockwise and remove.
2.	See Figure 3. Install wheel lock (1) onto brake disc. a. See Figure 1. Install reminder cord (2). b. See Figure 4. Install one loop end (1) to end of grip. c. Install other loop end (1) to wheel lock key cylinder.
3.	Press top of key cylinder down approximately half-way and listen for two beeps.
4.	Continue to press until it clicks into place. a. This indicates disc lock is locked.
5.	If one beep is heard: a. Allow key cylinder to go upwards till it stops. b. Slowly press top of key cylinder back down half-way and listen for two beeps. c. If this is heard, continue to push all the way down until it clicks. d. The disc is now locked.

1	Wheel lock

Figure 3. Lock Installed on Wheel

1	Loop end
2	Reminder cord

Figure 4. Disc Lock and Reminder Cord Installed

BATTERY LIFE

A lithium (CR2) Battery is included and should last 8-12 months with normal use, however frequent triggering or extreme temperatures, especially in colder climates can shorten battery life.

Battery is low when the lock begins to chirp. The lock will then burst out a 10 second continued siren. After 10 seconds the siren will stop and emit a warning tone.

IF ALARM IS DAMAGED

The alarm module is removable. Replacement modules are available from Kryptonite either through purchase or under the limited warranty. Submit a request for replacement through our website: www.kryptonitelock.com.

KEY SAFE – FREE KEY REGISTRATION AND KEY REPLACEMENT PROGRAM

For as long as the customer owns the lock, if keys are lost and key number has been registered with Kryptonite, Kryptonite will send first pair of standard replacement keys for FREE. To register keys, complete form on Kryptonite’s website at Kryptonitelock.com

CARE AND MAINTENANCE

NOTE

Do not use WD-40®.

WD-40 is a solvent, not a lubricant and will remove lubricant in the cylinder.

Lubricate lock several times a year to keep lock in optimum working condition. Always use a lubricant that has a silicone, graphite or Teflon™ base.

1.	Face lock cylinder upright.
2.	Spray or pour lubricant into lock cylinder.
3.	Let it sit for 5 minutes.
4.	Place a rag on workstation.
5.	Turn lock over onto rag for a few minutes.

TWO- YEAR LIMITED ELECTRONIC PRODUCT WARRANTY

Schlage Lock Company, LLC, through its Kryptonite division (“Kryptonite”) extends a 2-year limited warranty (excluding single cell batteries) to the original user of the alarm module manufactured by Kryptonite (the “Products”) against defects in material and workmanship. This warranty only applies to the Original User of Products. This warranty is not transferable. This warranty gives you specific legal rights, and you may also have other rights, which vary from location to location.

For complete warranty information on Kryptonite locks and lights and additional terms and conditions please visit Kryptonite’s website at www.kryptonitelock.com or call Kryptonite at 1-800-729-5625 (USA Only) or 001 781-828-6655.

To contact Kryptonite, go to www.kryptonitelock.com or call 1-800-SAY-LOCK (USA Only) or 001 781-828-6655.

LIFETIME LIMITED MECHANICAL PRODUCT WARRANTY

Schlage Lock Company, LLC, through its Kryptonite division (“Kryptonite”) extends a limited lifetime warranty to the original user of the products manufactured by Kryptonite (the “Products”) against defects in material and workmanship. This warranty only applies to the Original User of Products. This warranty is not transferable. This warranty gives you specific legal rights, and you may also have other rights, which vary from location to location. For complete warranty information and additional terms and conditions please visit Kryptonite’s website at www.kryptonitelock.com or call Kryptonite at 1-800-729-5625 (USA Only) or 001 781-828-6655.

To contact Kryptonite, go to www.kryptonitelock.com or call 1-800-SAY-LOCK (USA Only) or 001 781-828-6655.

ANTI-THEFT PROTECTION OFFER (ATPO)

Kryptonite’s Anti-Theft Protection Offer (“Offer”) is an optional Offer that reimburses registered customers up to a specific monetary amount in the event their bike or powersport vehicle is stolen due to the unintended opening or breaking of the lock by force. The ATPO is available to customers who purchase certain u-locks, chains, disc locks & folding locks (ATPO noted on package and on website) in the following countries: Austria, Belgium, Bulgaria, Canada, Croatia, Czech Republic, Denmark, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Israel, Italy, Latvia, Lithuania, Luxembourg, Netherlands, Norway, Poland, Portugal, Romania, Slovenia, Spain, Sweden, Switzerland, United Kingdom, and the United States. To locate the ATPO protection amount, look for the sticker on the front of the Kryptonite lock package or check the product page on Kryptonite’s website (www.krytonitelock.com). To be eligible a customer must register online at the Kryptonite website (www.krytonitelock.com) within 30 days of lock purchase. All reimbursements under such Offer are subject to the Kryptonite Offer’s terms and conditions.

To register, visit Kryptonite’s website and click on the “Register for Anti-Theft Protection” button right on the homepage of the Kryptonitelock.com site.

If a customer does not have internet access, they may request the registration documents by contacting Kryptonite in the United States via phone at 800-SAY-LOCK (729-5625) or 001 781-828-6655. The following information is required for registration: Customer contact details, lock information including a copy of the itemized receipt of purchase, key number of the subject lock, vehicle information including vehicle type (bike/powersport), base cost, serial #, an itemized copy of the bill of sale, and an image of the bicycle or powersport vehicle.

NOTE

If a customer has a custom or used bike or powersport vehicle and does not have a copy of the bill of sale, please provide an appraisal from a dealer that reflects the current value of the bike or powersport vehicle.

Registration fees range from just $9.99 for a one (1) year period to $29.99 for a five (5) year period. Products designed by Kryptonite as High & Ultimate security products are free to register for one (1) year and range up to $24.99 for five (5) years.

If eligible (based on the Offer terms and conditions), Kryptonite will reimburse the customer the lesser of 1) the base cost of the bike or powersport vehicle, excluding tax and accessories, in accordance with the amount listed for the subject lock; or 2) the theft deductible under any applicable insurance policy.

NOTE

Cables and accessories are NOT covered under this Offer. If a customer purchases a u-lock/cable combination pack the u-lock is the only product covered under this Offer. Any theft occurring with the cable is not covered, as the cable is a secondary deterrent. See the product packaging for specific details on the proper use of this type of product.

For additional information regarding this Offer, please check out Kryptonite’s ATPO FAQ section at kryptonite.zendesk.com. Questions may be submitted to Kryptonite through its website at www.krytonitelock.com, or stop by a local independent bicycle or powersport dealer.