SIGNATURE LED TURN SIGNAL INSERT
941003052021-05-18
GENERAL INFORMATION
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) |
|---|---|---|
67801329 | Safety Glasses, Flat head screwdriver, Rubber mallet |  |
(1) Only simple tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Signature LED Turn Signal Insert Components
Table 2. Kit Contents: Signature LED Turn Signal Insert Components
 | Item | Qty | Description | Part No. | Notes |
|---|---|---|---|---|---|
 | 1 | 2 | LED turn signal assembly | Not sold separately |
NOTE
Verify that all contents are present in the kit before installing or removing items from vehicle.
GENERAL
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Verify that the most current version of the instruction sheet is used. It is available at: www.harley-davidson.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNINGRider and passenger safety depend upon the correct installation of this kit.
If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation.
Improper installation of this kit could result in death or serious injury. (00308b)
REMOVE
| 1. | See Figure 2. Remove Original Equipment (OE) lens (1). | |
| 2. | Remove bulb (2). |
| 1 | Lens |
| 2 | Bulb |
| 3 | Bullet housing |
Figure 2. OE Lens and Bulb Removal
INSTALL
| 1. | See Figure 4. Install connector end of LED assembly (1) to bullet housing (2). NOTE See Figure 3. Reference label (3) on front of LED for proper orientation. | |
| 2. | See Figure 3. Align LED assembly so that hinge (1) is in the 12 o'clock position and drain hole (2) in the six o'clock position. NOTE If insert does not snap into place easily, cover insert with a piece of cloth and gently tap with a rubber mallet. Verify that lens is flush with housing. Snaps may not be heard if using rubber mallet to assist with install. | |
| 3. | See Figure 4. Install LED assembly (1) into bullet housing (2). a. See Figure 3. Install hinge (1) into groove at top of bullet housing. b. Swing bottom of LED assembly into bullet housing. c. Snap into place. | |
| 4. | Repeat on other side. |
NOTE
After installation of new turn signal inserts, verify proper operation. If turn signals appear to flash quickly, BCM will need to "learn" the new current setting of LED inserts. To put BCM in this "learn" mode, flash hazards for 30 seconds. Then turn hazards off and recheck flash rate of turn signals
| 1 | Hinge, 12 o'clock position (protrusion) |
| 2 | Drain hole, six o'clock position (narrow opening) |
| 3 | Label |
Figure 3. Hinge/Slot Location
| 1 | LED assembly |
| 2 | Bullet housing |
Figure 4. LED Assembly Install
COMPLETE
| 1. | Check operation of all lamps. |