GENERAL INFORMATION

Table 1. General Information

Kits	Suggested Tools	Skill Level⁽¹⁾
93100073	Safety Glasses	1 Dark wrench

(1) Only simple tools and techniques required

KIT CONTENTS

Figure 1. Kit Contents: Adjustable Travel Cover

Table 2. Kit Contents: Adjustable Travel Cover

Verify that all contents are present in the kit before installing or removing items from vehicle.
Item	Qty	Description	Part No.	Notes
1	1	Travel cover, large	Not sold separately
2	1	Travel cover bag	Not sold separately

GENERAL

Models

For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.

Verify that the most current version of the instruction sheet is used. It is available at: h-d.com/isheets

Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.

PREPARE

1.

Park vehicle with steering turned to left.

INSTALL

APPLICABILITY

NOTE

DO NOT INSTALL ON HOT EXHAUST.

Rear of cover has reflective square on outside and care label on inside.

Do not use on vehicle if it is being trailered.

1.	See Figure 2. Drape cover over bike, positioning front over the windshield or fairing.
2.	See Figure 3. Pull cover tight over rear of bike. a. With tour pack – pull material over top of backrest. b. With P&A back rest – pull over back rest. c. Adventure Touring – pull over tour pack or rear fender. d. Other bikes - pull over rear lights or LP light.
3.	See Figure 4 and Figure 5. Attach elastic cords (2 per side) over any convenient attachment points. a. See Figure 6 and Figure 7. Engine guard. b. See Figure 8 and Figure 9. Foot controls. c. See Figure 10 and Figure 11. Passenger foot pegs or foot boards.
4.	Use of plastic clips is optional. a. Elastic cords can be relocated to other holes along edge of cover for better fit. b. If necessary, shorten cords by adding additional knots or retying existing knots.

Figure 2. Rear Coverage (typical)

Figure 3. Rear Coverage (typical)

Figure 4. Right Coverage (typical)

Figure 5. Left Coverage (typical)

Figure 6. Engine Guard Tie Down (Right)

Figure 7. Engine Guard Tie Down (Left)

Figure 8. Brake Pedal Tie Down

Figure 9. Shifter Tie Down

Figure 10. Foot Peg Tie Down

Figure 11. Floorboard Tie Down

COMPLETE

NOTE

The cover is water resistant and NOT water proofed. Water will seep through cover if it is allowed to puddle.

1.

When installed cover should have slope to keep water from collecting above seat area.

MAINTENANCE

NOTE

1.	Brush off normal dirt with cloth.
2.	Spot clean with warm water and mild detergent. Use sponge or terry cloth.
3.	Cover should be thoroughly dried before use.