LOW-PROFILE SOLO TOURING SEAT

941004482024-01-24

GENERAL INFORMATION

Table 1. General Information

Kits	Suggested Tools	Skill Level⁽¹⁾
52000690, 52000691	Safety Glasses, Torque Wrench

(1) Only simple tools and techniques required

KIT CONTENTS

Figure 1. Kit Contents: Low-Profile Solo Touring Seat

Table 2. Kit Contents: Low-Profile Solo Touring Seat

Verify that all contents are present in the kit before installing or removing items from vehicle.
Item	Qty	Description	Part No.	Notes
1	1	Seat	Not sold separately
2	2	Custom nut	10400077

GENERAL

Models

For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.

Verify that the most current version of the instruction sheet is used. It is available at: h-d.com/isheets

Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.

Installation Requirements

WARNING

Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)

NOTE

This instruction sheet references service manual information. A service manual for the year and model motorcycle is required for this installation and is available from:

A Harley-Davidson dealer.
H-D Service Information Portal, a subscription-based access available for most 2001 and newer models. For more information see Frequently ask questions about subscriptions.

PREPARE

Remove Original Equipment (OE) seat. See service manual.

a. Remove grab strap and nuts.

REMOVE

See Figure 2. Remove nuts (1).

a. Leave plastic retaining washers (2) installed.

1	Nut (2)
2	Plastic retaining washer (2)

Figure 2. Plastic Retaining Washer

INSTALL

NOTE

If a pillion seat kit is being installed, install passenger grab strap from that kit onto studs and under seat.
When a solo seat is installed without a passenger seat, passenger footpegs or footboards and passenger grab strap must be removed.

1.	See Figure 3. Install new solo seat (2). a. Position seat until front tab engages frame and rear of seat over mounting studs.
2.	Install seat custom nuts (1) onto studs. a. If a pillion is not being installed, pull down flap at the rear of the seat to cover the mounting studs.

1	Custom nut (2)
2	Solo seat

Figure 3. Solo Seat

COMPLETE

After installing seat, pull upward on seat to be sure it is locked in position.