TALL WINDSHIELD MOUNTING BLOCKS
941004752023-06-07
GENERAL INFORMATION
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) |
|---|---|---|
57400668 | Safety Glasses, Torque Wrench |  |
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Tall Windshield Mounting Blocks
Table 2. Kit Contents: Tall Windshield Mounting Blocks Kit
 | Verify that all contents are present in the kit before installing or removing items from vehicle. | ||||
|---|---|---|---|---|---|
Item | Qty | Description | Part No. | Notes | |
 | 1 | 1 | Tall windshield mounting block, right | Not sold separately | |
| 2 | 1 | Tall windshield mounting block, left | Not sold separately | |
Items mentioned in text, but not included in kit | |||||
| A | 4 | Original Equipment (OE) screw | ||
GENERAL
Models
For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.
Verify that the most current version of the instruction sheet is used. It is available at: h-d.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
These items are available at your local Harley-Davidson dealership:
- Separate purchase of Tall Windshield kit is required.
WARNINGRider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for the year and model motorcycle is required for this installation and is available from:
- A Harley-Davidson dealer.
- H-D Service Information Portal, a subscription-based access available for most 2001 and newer models. For more information see Frequently ask questions about subscriptions.
PREPARE
| 1. | Remove windshield if present. |
REMOVE
| 1. | See Figure 2. Remove right and left mounting block screws (2). Retain screws. | |
| 2. | Remove cover from duct assembly. See service manual. | |
| 3. | Remove screws retaining right and left mounting blocks from underside of cover. a. Discard mounting blocks and retain screws for later use. |
| 1 | Mounting block (2) |
| 2 | Screw (4) |
Figure 2. Remove Mounting Blocks
INSTALL
| 1. | See Figure 3. Install new mounting blocks to cover. a. Align and engage mounting block alignment pin with hole in cover. b. Secure mounting block to cover with OE screw. Tighten. Torque: 2.5–3.6 N·m (22–32 in-lbs) c. Repeat on other side. | |
| 2. | Install cover to duct assembly. See service manual. | |
| 3. | See Figure 1. Secure right and left mounting blocks (1,2) with OE screws (A). Tighten. Torque: 2.8–3.4 N·m (25–30 in-lbs) |
| 1 | Alignment pin, right mounting block |
| 2 | Alignment pin, left mounting block |
| 3 | "R", right mounting block |
| 4 | "L", left mounting block |
Figure 3. Right / Left Mounting Block Alignment Pin Locations