FORGED CARBON FIBER SEAT COWL
941005292024-04-29
GENERAL INFORMATION
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) |
|---|---|---|
61301374 | Safety glasses, Torque wrench |  |
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Seat Cowl Assembly
Table 2. Kit Contents: Seat Cowl Kit
 | Verify that all contents are present in the kit before installing or removing items from vehicle. | ||||
|---|---|---|---|---|---|
Item | Qty | Description | Part No. | Notes | |
 | 1 | 1 | Seat cowl | Not sold separately | |
| 2 | 1 | Gasket (not shown) | 61301382 | |
GENERAL
Models
For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.
Verify that the most current version of the instruction sheet is used. It is available at: h-d.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
Seat cowl is only compatible with Touring solo seats. It does not fit with 2up seats and requires reuse of existing pillion thumb screw or separate purchase of pillion thumb screw if vehicle does not already have one.
WARNINGRider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for the year and model motorcycle is required for this installation and is available from:
- A Harley-Davidson dealer.
- H-D Service Information Portal, a subscription-based access available for most 2001 and newer models. For more information see Frequently ask questions about subscriptions.
PREPARE
| 1. | Remove pillion assembly. See service manual. |
INSTALL
NOTE
- See Figure 2. Seat cowl bracket slots (5) fit into seat mount nuts (4) in this location.
- Front of seat cowl to be properly engaged in mounting slots.
- Seat cowl mounting tabs can not be resting on top of mounting posts.
| 1. | Lift up rear cover of rider seat (6) to expose seat mount nuts (4). | |
| 2. | Slide seat cowl (3) forward to engage it into seat mount nuts. | |
| 3. | Install washer (2) and screw (1). Tighten. Torque: 1–1.7 N·m (9–15 in-lbs) Seat cowl screw |
| 1 | Screw |
| 2 | Washer |
| 3 | Seat cowl |
| 4 | Seat mount nuts (2) |
| 5 | Seat cowl bracket |
| 6 | Rider seat |
Figure 2. Seat Cowl
CARE AND MAINTENANCE
Cowl is painted with a matte clear coat and they should not be polished as that would cause an irreparable glossy spot on the part and potentially remove the protective top coat.