SCREAMIN' EAGLE TIMER COVER MEDALLIONS
941005922024-01-23
GENERAL INFORMATION
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) |
|---|---|---|
14102070, 14102071, 14102072, 14102073 | Safety Glasses, isopropyl alcohol, grease pencil |  |
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Screamin' Eagle Timer Cover Medallion
Table 2. Kit Contents: Screamin' Eagle Timer Cover Medallion
 | Verify that all contents are present in the kit before installing or removing items from vehicle. | ||||
|---|---|---|---|---|---|
Item | Qty | Description | Part No. | Notes | |
 | 1 | 1 | Screamin' Eagle Timer Cover Medallion - 117 Stage I | ||
| Screamin' Eagle Timer Cover Medallion - 117 Stage II | ||||
| Screamin' Eagle Timer Cover Medallion - 121 Stage I VVT | ||||
| Screamin' Eagle Timer Cover Medallion - 121 Stage II | ||||
GENERAL
Models
For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.
Verify that the most current version of the instruction sheet is used. It is available at: h-d.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNINGRider and passenger safety depend upon the correct installation of this kit.
If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation.
Improper installation of this kit could result in death or serious injury. (00308b)
REMOVE
NOTE
Careful not to scratch paint or surface.
| 1. | Remove Original Equipment (OE) camshaft cover insert using plastic pry tool or fishing line. NOTE Use hair dryer low heat to loosen adhesive, or remove while engine is still warm. |
INSTALL
NOTE
- Ambient temperature during Camshaft Cover Insert installation must be at least 20.0 °C (68 °F).
- Camshaft Cover Insert installation at temperatures below 20.0 °C (68 °F) will cause failure of the adhesive bond.
- Do not sand or scuff surface where Camshaft Cover Insert are to be installed.
- After applying Camshaft Cover Insert, allow a minimum of 24 hours before exposing the area to vigorous washing, strong water spray or extreme weather.
| 1. | Clean area with isopropyl alcohol. Dry with a lint free cloth. | |
| 2. | Test fit new camshaft cover insert. | |
| 3. | Use a grease pencil to mark location. | |
| 4. | Remove adhesive backing from camshaft cover insert. | |
| 5. | Install camshaft cover insert using marks made earlier as a guide. | |
| 6. | Press firmly in place with steady pressure for one minute. |