"Harley-Davidson Motor Co." Timer Cover
J009052013-11-01
GENERAL
Kit Numbers
32666-98, 32667-98, 32668-98, 32669-98
Models
For model fitment information, see the P&A retail catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
INSTALLATION
WARNINGTo prevent accidental vehicle start-up, which could cause death or serious injury, disconnect battery cables (negative (-) cable first) before proceeding. (00307a)
- Use a 3/8 in. drill bit and drill the heads off the original timer cover rivets. Remove original timer cover.
- Remove and discard inner cover retaining screws. Leave gasket (if used) and inner cover in position.
- See Figure 1. Place washers (1) over rivets (2) and place rivets into inner cover holes so the backs of the rivets go into the sensor plate screws' tapped holes.
- Use a standard rivet tool and install rivets, securing inner cover to sensor plate screws.
- Use the self-tapping screw to cut threads into the remaining inner cover holes. Discard screw after use.
- Place new timer cover in position over inner cover and secure with chrome screws (4).
NOTE
To make the cam position sensor tamper proof, follow steps 2 through 4. If the cam position sensor is not required to be tamper proof, skip steps 2 through 4.
NOTE
If the inner timer cover has been riveted in place and access to the cam position sensor is required, use a left hand drill and carefully remove the rivet heads. If a right hand drill is used, the sensor plate screw heads could break off when trying to remove the rivet.
Figure 1. Service Parts
Table 1. Service Parts
Item | Description (Quantity) | Part Number |
|---|---|---|
1 | Washers (2) | 6335 |
2 | Rivets (2) | 8501 |
3 | Timer cover | Not sold separately |
4 | Timer cover screws (2) | 94555-97 |
5 | Self-tapping screw (not shown) | 3659 |
Items mentioned but not included in kit. | ||
A | Gear Case | Not sold separately |
B | Sensor plate Screws | |
C | Gasket | |
D | Inner Cover | 29960-85 |