0/0
CHROME SPARK PLUG/HEAD BOLT COVERS
J012162007-07-24
GENERAL
Kit Number
43835-98
Models
For model fitment information, please see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Kit Contents
Table 1. Kit Contents
Description
Part Number
Head bolt cover, rear
Not Sold Separately
Head bolt cover, front
Not Sold Separately
INSTALLATION
  1. See Figure 1. Pull the spark plug wire caps (1) off of each spark plug.
  2. Turn each spark plug/head bolt cover (2) over. The cover for the front is stamped with an "F" and the cover for the rear is stamped with an "R".
  3. Firmly push each cover in place over the corresponding front and rear spark plugs. Make sure the rubber grommets are in place over each head bolt and spark plug.
    4. NOTE
    It may be necessary to trim back the spark plug wire boot up to 1/4 inch to provide the proper "snap" fit between the wire connector and the spark plug.
  4. Install the spark plug wires onto the spark plugs and push the wires on far enough so you can feel them snap into place.
  5. After installing the spark plug wires, pull gently upward on spark plug wires to be certain they are locked into place. If spark plug wires are not properly attached, it may result in poor engine performance due to lack of spark to one or both cylinders.
1Spark plug wire caps
2Spark plug/head bolt cover
Figure 1. Spark Plug/Head Bolt Covers